Electronics Forum: clamps (Page 1 of 29)

SAMSUNG nozzles

Electronics Forum | Wed May 25 19:04:39 EDT 2005 | russ

check your clamping rails and see if you see any little wear marks, we constantly hit these clamps during placement when the parts are too close to the edge. The height of that clamp is either 4 or 6mm I beleive and the noozles will hit them on occ

DEK265 GSX chase clamp error

Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas

screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st

Quad Qsv-1 Low House Air Pressure

Electronics Forum | Fri Feb 29 08:27:34 EST 2008 | tbkonrad

This morning I turned on our Qsv-1 and ai resiveved the following error. "Clamp did not open: House Air pressure may be lower then 70 psi" after checking the Air Pressure it reads at 80 psi on the Main air pressure gauge as well as the 80 psi on the

Re: Printing smear

Electronics Forum | Thu Dec 16 06:06:52 EST 1999 | Stefan

Check the print gap and check the clamp edges, sometimes the clamps is damaged causing a distance between the PCB and the screen. Good luck

Ceramic Substrates

Electronics Forum | Mon Sep 17 09:44:29 EDT 2001 | gresko

Dave, Ceramic sheets of that size are not always flat and as a result will sometimes crack when clamped along the full edge. Point clamping will hold the substrate secure for placement. If you are not processing in a pallet make sure that you have

Solder printing issues

Electronics Forum | Wed Nov 13 23:50:23 EST 2002 | iman

we changed our top/bottom clamping system in the Printer, to a side-edge clamping system. This removed the higher paste issue similar to your thread.

CP643E Ref Side Clamp Mesh Error

Electronics Forum | Thu Aug 07 11:17:51 EDT 2003 | 51165

Can someone help me with a Ref Side Clamp Mesh Error on a CP643E?

SAMSUNG nozzles

Electronics Forum | Wed May 25 19:11:49 EDT 2005 | jsloot

That I can do, checking the placement height that is and the clamps. I believe my clamps are 4mm. If your nozzles have survived 5 years how many placements is that...roughly? In the billions?

MPM 3000 PROBLEM

Electronics Forum | Thu Apr 06 18:31:27 EDT 2006 | jsloot

Any one familiar with a board clamp problem on MPM UP3000? The one I have will not clamp the board when program is running. It will work when toggled through the output diagnostics. Any help is appreciated.

UP2000 with grid-lok question

Electronics Forum | Tue Jan 23 13:15:44 EST 2007 | stepheniii

Shouldn't the top of the board be at the exact same height as the top of the side clamps? Why are the clamps holding the stencil up off the board?

  1 2 3 4 5 6 7 8 9 10 Next

clamps searches for Companies, Equipment, Machines, Suppliers & Information