Electronics Forum | Tue Feb 17 13:04:14 EST 2015 | longnguyen
I am looking for the Manual and the Conveyor belt fluid cleaner for the Electrovert Bravo 8105, the conveyor belt fluid container is near the front with the brush point down to belt ( closed to the monitor ), any one know where can i buy this Manual
Electronics Forum | Thu Mar 12 22:32:49 EDT 2015 | louisg
Hello. I would like to know the difference (if any) between water soluble flux and test socket cleaners (e.g. for Burn-In Board test sockets). As far as I know, they both remove oxides (tin & copper) with an activator, solvent and surfactants. Tha
Electronics Forum | Wed Jan 05 17:19:56 EST 2022 | emeto
We use Benchmark Smartsonic 6000 for the last 20years. Recently evaluated replacement. Candidates we picked now are close loop systems, smaller footprint and use smaller tanks. Cleaners evaluated - Kolb-PS300, Systronic cl420 and DCT inkjet 388. We p
Electronics Forum | Tue Nov 07 10:09:51 EST 2000 | Kevin
John, Depends on what you're cleaning (paste, adhesive, ink, etc..) and your process (do operators just dump a dirty stencil in and expect a clean one out, drying time, effect on the polyester). I could suggest a couple of name brand cleaners, but I
Electronics Forum | Mon Mar 05 13:08:16 EST 2001 | billschreiber
Hi Roger, Our customers use their Smart Sonic Stencil Cleaners for cleaning SMT and wave pallets. There are two primary protocols used. 1) If you have a large quantity of pallets and they are becoming contaminated rapidly, a dedicated stencil clean
Electronics Forum | Wed Jun 24 16:45:18 EDT 1998 | Bill Schreiber
| I know this topic has probably been talked about before...But I ran into a small situation where Solder Balls were appearing in large quantities on the PCB....the Problem has been isolated and taken care of, my question is, what are some good metho
Electronics Forum | Tue Jan 05 20:29:32 EST 1999 | Steve Gregory
| A question for you all! | | Back in the good old days, we didn't always know how clean was clean. Much has changed. Much hasn't. | | My question concerns cleaning under, through, and around tight spaces. Way back when, we could not clean under 20
Electronics Forum | Wed Jan 06 09:55:22 EST 1999 | Chrys
| | A question for you all! | | | | Back in the good old days, we didn't always know how clean was clean. Much has changed. Much hasn't. | | | | My question concerns cleaning under, through, and around tight spaces. Way back when, we could not clea
Electronics Forum | Tue Oct 12 17:24:27 EDT 1999 | Kevin Ham
| | A question for you all! | | | | Back in the good old days, we didn't always know how clean was clean. Much has changed. Much hasn't. | | | | My question concerns cleaning under, through, and around tight spaces. Way back when, we could not clea
Electronics Forum | Wed Feb 21 18:07:00 EST 2001 | billschreiber
Hi Ramon, The obvious answer you might expect to here from me is that you could probably reduce your misprint problem if you had a good stencil cleaning process. Please see my response to the question by MarkT on �Cleaning Materials� because it i