Electronics Forum | Thu Jul 27 14:48:26 EDT 2000 | Bob Barr
Is Mil-I-46058 still an active spec or has it been obsoleted by the Feds in favor of IPC specs? I have an internal process document that is based on IPC requirements, but a customer wants me to use their specs that are based on the mil spec. I am ho
Electronics Forum | Tue Jul 11 10:10:55 EDT 2000 | John Thorup
Low static Kapton dots are available from Shercon (www.shercon.com) and through many distributors like com-kyl. Purpose specific dots are available from Circuit Technology Center as TD-250 Tape Dots. (www.circuittechcenter.com). Consider also The Pr
Electronics Forum | Mon Jun 26 17:28:55 EDT 2000 | Mike Demos
Chrys & Dave: Thanks for your replies. Scoring won't work in this case. There are some overhanging components and some 90 degree routes as well. My experience with scoring has been similar to Chrys'. For large panels I also had some issues with
Electronics Forum | Wed May 03 20:19:31 EDT 2000 | Dave F
Sal: Sorry, sometimes (more often than I�d like to admit) I�m a bit dense. But first � Leaching. Dissolution of a metal coating into liquid solder. Leaching applies to liquid solder and is applied inaccurately to metallurgical effects, like diff
Electronics Forum | Mon May 01 17:12:42 EDT 2000 | Joe
I have the same equipment and the same chemicals and have had the same problem. The part of the stencil which is glued to the mesh is being destroyed by the ultra sonics in the equipment. The only solution I found is to seal the glued part of the ste
Electronics Forum | Wed Feb 21 11:25:04 EST 2001 | Dave E
We have had a problem with some resistors on some conformally-coated boards which, after a few months in the field, started going bad -- a real worst-case situation. The resistors would increase in value dramatically and sometimes develop diode-like
Electronics Forum | Tue Feb 27 18:13:03 EST 2001 | davef
First used a Binks for painting a '57 Chebby that Wesley B and I were rebuilding. We still use them for spraying conformal coatings. If Chrys was here, she�d freak. Look at: http://www.smtnet.com/library/index.cfm?fuseaction=view_article&article_i
Electronics Forum | Wed May 02 16:20:01 EDT 2001 | mparker
As a second thought, just to address your problem, try contacting a local fabrication shop for restaurant supply. They are used to working with stainless steel. I once had a complete sink/workstation top fabricated to my specs. for a fraction of the
Electronics Forum | Wed May 02 22:33:44 EDT 2001 | davef
Silvio Dante (played by former E Street Band Guitarist Steve Van Zandt, in his acting debut) has even turned an extremely passing resemblance to Al Pacino [Godfather, Part III] into a personality; he�s forever curling down the corners of his mouth an
Electronics Forum | Wed May 02 22:36:50 EDT 2001 | davef
I hear ya and yer probably correct, but the drives on the pup are whipped and I wasn't aimin to spend much time with it, yano. Just order some parts, slap 'em in, and get bustin'. But that just may not be what Ima gunna do, whether I like it or not