Electronics Forum | Fri Jan 22 10:17:47 EST 1999 | LeeAnne
I have boards coated with Humiseal 1B73. At a late point mfg. site we need to remove a series of 0603 resistors for optioning purposes. I have been trying to determine the fastest, easiest way to re-coat the pads after removal. Drying time of the coa
Electronics Forum | Tue Oct 06 15:50:12 EDT 1998 | Bill Tuttle
We are experiencing poor wetting on various components placed on a PCB with En-Tek coating. Is anyone else experiencing simular problems ? We have the following questions: 1. How can the thickness of the En-tek coating be measured? 2. Is En-tek vol
Electronics Forum | Thu Jun 10 21:09:17 EDT 1999 | Samuel F.
Humiseal probably won't work as most of them are solvent based or require pretty high temp cures. MicroCoat technologies manufacturers UV cure epoxy conformal coating materials that have been used to coat just about anythin (except the green fog) Cal
Electronics Forum | Wed Jul 22 15:35:44 EDT 1998 | Katy H
Check out Precision Valve & Automation Latham, NY Phone: 518-782-3436 They make a relatively inexpensive system for applying material. You can choose spray or valve dispensing or both. The product is built simply and has been relatively easy to set
Electronics Forum | Thu Jul 02 02:47:10 EDT 1998 | Graham Naisbitt
Wayne, We make such equipment both as batch and in-line systems, IR, UV curing as required. We have over 1000 systems installed worldwide. Are ISO9002 qualified. If you can let me have your address, I will get you more info. Maybe you could elaborate
Electronics Forum | Tue Jun 02 14:32:58 EDT 1998 | Chris Fontaine
We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is not alwa
Electronics Forum | Tue Jun 02 15:53:32 EDT 1998 | Earl Moon
| We have experienced poor adhesion of acrylic conformal coating to plastic bodied IC�s. The observed symptoms of this are a blistering or lifting of the coating at the surface of the component, although peel testing has revealed that this is not al
Electronics Forum | Fri May 29 14:22:27 EDT 1998 | Chrys
| Does anyone out there can let me know how to clean a Entek Coating Board if I have a misprint during solder paste printing? According to the guys at Enthone, squeegee most of the paste off, then use Kyzen Lonox (which only removes 3% of the coating
Electronics Forum | Fri Dec 07 15:17:06 EST 2001 | davef
Dull / shiny, I�m not sure that�s a proper indicator. If �Liquid Tin� adds a thin coat of solderable material without converting the corrosion on the surface of the lead, the corrosion will [probably] continue to increase and potentially affecting t
Electronics Forum | Wed Mar 27 21:20:30 EST 2002 | davef
There is two major BGA coating camps. * Camp #1: "We require the coating to be under low stand-off devices but with no filleting. So we apply a thinned dip coat first, and then top-off with a proper spray coat" * Camp #2: "We want no coating under th