Electronics Forum: coding (Page 16 of 84)

Re: 0603 marking

Electronics Forum | Fri Mar 31 03:42:41 EST 2000 | Chris May

Typical idents are as follows, but not limited to:- 5% 3 digits, first two are significant figures, third is number of zeros and letter "R" is decimal point. 1% 4 digits, first three are significant figures fourth digit is number of zeros and lette

CP642's vision process error

Electronics Forum | Mon Jul 28 17:13:28 EDT 2003 | Ryan Liao

Hello dear all: I have some problems with the CP642's vision process system . When the machine is working, sometimes the vision process system will appearance the error message. Error code :��1CA0A007�� Element code: FFFF Segment code: 0000 This s

Universal Instruments PPU Transferring programs?

Electronics Forum | Fri Aug 27 12:00:54 EDT 2004 | pemnut

Looking in My book, it describes "E" in the last data field as follows. Load error. This function code is not programmed as part of a pattern step. The controller uses the E code as an error marker. While a pattern program is being loaded into memory

GSM Camera Focus

Electronics Forum | Mon Aug 28 10:51:51 EDT 2006 | SWAG

http://www.brigarelectronics.com/Merchant2/merchant.mv?Screen=PROD&Store_Code=BE∏uct_Code=GP-MF552&Category_Code=C Seems to be working well. I didn't remove the housing from the machine = recal. The placements are right on, it's just a bit out of f

Mydata package libraries

Electronics Forum | Tue Oct 24 13:41:25 EDT 2006 | jax

Everybody who uses basic "part-type" naming conventions for machine package codes will have this same issue unless restrictions are placed on who, how, and when the package codes can be altered. Some alternative methods to solving this problem: 1. U

Gerver vs. ODB++ in case of there's some Impedance control line

Electronics Forum | Fri Apr 03 02:15:23 EDT 2009 | roy1209

I've heard from my company's engineer that it'll be better to use Gerber format if there's some impedance control line . Because usually Gerber has code numbers in data and someone can easily refer to controlled line on the PCB and ODB++ doesn't have

Quad IVc pickup problem

Electronics Forum | Tue May 10 09:45:53 EDT 2011 | veeckm

After changing mod codes 50,51 and 54,55 respectively on the HHT I will then goto ccconfig.sys file in the central controller software and manually enter in the new mod code values. I do not do any uploading/downloading of mod codes through database

Quad 4C part placement rejection

Electronics Forum | Fri Nov 18 16:26:17 EST 2011 | olddog

Hi again Bob, I checked the theta motor coupling and the set screws are definately tight. I noticed that the theta motor drives an snti-backlash gear (nice design) so there is no play there. It appears that the gear drives a slotted shaft which is d

AOI, Quality and SPC

Electronics Forum | Mon Mar 03 13:18:02 EST 2003 | msivigny

Hello phil, The use of AOI systems give us the opportunity to auto-collect defect information much the way you're using them now. AOI systems become extremely effective when the collected data is used to perform some positive change into the process.

Re: Question on Grounding Resistor

Electronics Forum | Tue May 23 20:35:03 EDT 2000 | Dave F

Ashok: Our procedure allows connecting a resistor of less than 1 Mohm between the mat and ground, if safety codes and/or other authorities require inclusion of a series resistor (to eliminate the safety hazard of touching a high voltage circuit with


coding searches for Companies, Equipment, Machines, Suppliers & Information