Electronics Forum | Tue Nov 06 06:23:31 EST 2007 | clampron
Good Morning Roger, The Mirtec's can be adjusted to lower your false call rate. This can be done by reducing the matching percentage for each componnent but the result of this action is that the machine becomes less selective. If you lower them too
Electronics Forum | Mon Sep 22 17:02:58 EDT 2008 | hegemon
You are on the right track Ismir. Essentially however, as the programmer of the machine, I am the one that creates the PCB with the errors to benchmark the settings for the machine. No secret lab though! :-) Easy enough for most any AOI machine to
Electronics Forum | Tue Nov 04 10:47:54 EST 2008 | rway
Thank you all for the great responses. We to looked at tne Mirtec before settling on the YesTech. I felt the machine software was better structured and organized and the system caught more faults on our "broken" board than the other system did (We
Electronics Forum | Thu Dec 18 13:05:59 EST 2008 | tsvetan
we have omron, before buy I have evaluated lot of other machines, what I like most is the three ring at different angle lighting which allows pseudo 3-d solder joint evaluation and historgams with statistics, you can see out of total solder joints ho
Electronics Forum | Mon Jan 26 13:13:07 EST 2009 | rgduval
We've had this same problem with the solder wicking to the component terminations. However, in our case, we did not see the pads turning a silver-white color...rather, they exhibited a tarnishing/darkening of the gold. We determined that we had som
Electronics Forum | Tue Mar 24 20:25:18 EDT 2009 | davef
It is very common to use low residue flux with low-standoff parts. On the other hand, sure you can clean under low-standoff parts. We've talked about this previously. Search the fine SMTnet Archives to find threads like: http://www.smtnet.com/Forums
Electronics Forum | Mon Sep 21 20:45:55 EDT 2009 | davef
10.4. Pre-Cure Examination. Immediately after material application, the uncured conformal coating shall be examined for: a. Bubbles and Air Entrapments. These defects shall be broken by vacuum, with a sharp probe, or other appropriate tools. b. Bridg
Electronics Forum | Thu Mar 10 21:21:54 EST 2011 | thatguy
I have 7yrs experience with JUKI's and I liked 2000 series(2050,2060) dont get caught up in the 730 or 760 these machines are obsolete or at least on there way and spare parts are hard to come buy. The 2060 is the chip shooter. I like the user friend
Electronics Forum | Tue Apr 05 10:36:24 EDT 2011 | frcdave
Hi Don, The YESTech B3 can be used post placement very easily. I would suggest contacting their service team, they could walk you through the process quickly. You are actually very close to being able use it now in that capacity since you have the i
Electronics Forum | Thu Apr 07 09:24:47 EDT 2011 | rway
What version of sw are you running? There are some new features in 2.7.7 and earlier that may be of benefit to you. With chip caps you are testing for presense/absense. The gain/offset feature can be used to give you better contrast between the pa