Electronics Forum | Wed Apr 19 09:07:44 EDT 2006 | russ
Many times a pad that has no signal trace going to it will come off. It does happen from heat and time as noted before. Somtimes even the best rework person will remove them. If this can not happen in your situation I would recommend that you use
Electronics Forum | Fri Apr 21 18:02:16 EDT 2006 | SD
You didn't explain exactly how you are reworking the BGA and at what point the pad comes off. Assuming it's from an iron... The biggest cause of lifted pads is too much heat. Whether it be the iron temp or the amount of time the iron is on the pad
Electronics Forum | Sat Sep 23 20:08:33 EDT 2006 | Mats
Hi, Maybe I am a little bit slow, but please explain exactly what is your point here? The RoHs directive is wrong, or what? So You slam the door on the RoHs directive, just because You don't get the whole picture or perhaps You do?