Electronics Forum | Fri Nov 02 17:50:11 EDT 2012 | hegemon
Rather than a catalogue af all the machines and their specs, you might start by defining what YOUR requirements are... some machines are better suited for low mix, high throughput, some better suited for low volume, high changeover rate. Ask yoursel
Electronics Forum | Thu Nov 29 11:06:47 EST 2012 | davef
Approaches to getting started are: * Most batch cleaning equipment suppliers provide both open and closed loop options on their machines. Talk to them about upgrading your machine. * There are companies that specialize in supplying closed loop system
Electronics Forum | Sun Dec 02 16:18:22 EST 2012 | sarason
A few years back when I was working in a Hybrid company we used carriers machined from aircraft grade aluminum. Its easy to machine on a Mill doesn't bend so easy when mishandled.The thing to know is do your flex circuits sit flat when placed on the
Electronics Forum | Tue Dec 11 12:02:55 EST 2012 | juggalo
The owner of the company is from India, I don't know if that has anything to do with his thinking. He told me that he runs his business like a garden not a military. So I wear my safety gear and I am not too concerned with his fines as he appears to
Electronics Forum | Wed Dec 12 08:31:35 EST 2012 | rway
You won't want to hear this, but I guess that depends where your tattoos are located, and whether you swear like a sailor around the company. It's perception and people will perceive you a certain way depending on your appearance and how you handle
Electronics Forum | Mon Feb 04 23:27:01 EST 2013 | armandogomez
Hello all!!! I have a question, since we first started here we have bought a lot of ICT fixtures for our old Z1820 teradyne we are a company that work with a lot of reed switches, no the question is can a reed switch be tested in the ICT? I have no
Electronics Forum | Tue Apr 30 21:35:36 EDT 2013 | cpcompany
Fraud, Danny Finally you shut down your phone and ran away because I am flying to Singapore. I will find you and put you in prision. You shall not put your feet in this business anymore. I will watch you wherever you go and stop you doing fraud! Ev
Electronics Forum | Wed Mar 13 19:56:34 EDT 2013 | hegemon
It has been some time since I programmed a mirtec machine, but I think the technique would be to break the component into different banks of leads with unique locations. U25_Top, U25_Right, U25_LEft, etc... Use the centroid location to check presence
Electronics Forum | Wed May 22 19:47:30 EDT 2013 | anvil1021
Also, I was just thinking that most of the large companies we work with do not consider via drain an actual void. As a matter of fact our high dollar super fantastic Xray system actually has a switch to turn off the vias during void detection so that
Electronics Forum | Thu Jun 13 08:53:25 EDT 2013 | markhoch
Ahhh yes. The infamous round rubber belts used on the Fuji CP2's and CP3's. :) I remember fondly using a pair of dykes and a Bic Lighter to make my belt repairs. Does anyone know if these are still available from Fuji? You may be able to find repl