Electronics Forum | Wed Aug 03 14:48:19 EDT 2005 | cyber_wolf
Mike, Lets say I am a U.S. based company, and I wanted your organization to "assess" a machine in Malaysia. Could you give us folks a ball park figure of what that might cost ? Doesn't have to be exact....Just a ball park figure........
Electronics Forum | Tue Aug 09 13:22:27 EDT 2005 | bobpan
i find it hard to believe that you cant get another shaft and replace it. I am sure they will always say not to do it...like every other company....but if you know the machine and if you know how to calibrate it.....I cant see a reason to not give it
Electronics Forum | Tue Aug 30 22:38:54 EDT 2005 | cabs
Does any one knows where to get a plating thickness meter that can be use in the fine pitch contacts and trace in PCB application like BGA pads? If there's a hand held device at lower cost much better... Also if you can recommend companies that offer
Electronics Forum | Wed Aug 31 06:36:44 EDT 2005 | Slaine
i looked at hand held XRFs for a similar application, but the smallest surface i could find one sampled was about 3mm diamiter and there about �30k but a few companies will lend you one dor trials, would tell you the plating thickness and metalic ele
Electronics Forum | Fri Oct 14 16:43:56 EDT 2005 | Denis
Hi, I think I'll try to do it on my own. There's a company here that does this stuff, called Car-San, but the want to charge me $100 Canadian to do one chip on one board. Min order, I guess. I think they were just trying to shoe me away. So, I bo
Electronics Forum | Thu Sep 15 13:52:40 EDT 2005 | pr
We had 2 at my last company. As I recall we had a hell of a time with bad blower motors. I'm not sure how you'd check on that, but maybe that problem has been fixed by now (it's been a few years). good luck, pr
Electronics Forum | Thu Sep 22 07:13:34 EDT 2005 | davef
You need to account for the time and exposure of each MSD component during your production processes. * Barcodes * Software * Procedures * Training * Etc Francois Monettet [fmonette at cogiscan.com ] at Cogniscan [ cogiscan.com ] is a frequent contr
Electronics Forum | Fri Oct 07 09:05:12 EDT 2005 | chunks
There's a ton of em'. We used the one from Paul N. Gardner Company, part # WF-CCD. They cost 0.95 each, so if someone decides the gage looks better in their garage, it's not that big of a deal. We set up a program that puts down 4 stokes on a test
Electronics Forum | Thu Oct 13 15:34:55 EDT 2005 | Amol
Hi, We are in the process of transitioning to LF production. What are some of board materials being successfully used in production? Also, what surface finishes show promice of good results with SAC 305 solder? We are currently testing multiple boar
Electronics Forum | Wed Oct 19 14:41:37 EDT 2005 | Frank
There are not too many Juki users that are active on this forum. I have been using them for over 10 years. Our company has had a variety of their machines as we have been upgrading over the years. We haven't had any major issues. Clean it up and
.gif)
