Electronics Forum | Tue Nov 19 09:50:58 EST 2002 | GSW
Hi, Need to know if anybody has good reliability data on Sn/Bi component termination and Sn/Pb solder paste ? thanks GSW
Electronics Forum | Wed Dec 04 09:46:15 EST 2002 | stefwitt
In a new design project, I would like to attach electronic components to a board using either sonic or resistance spot welding. Anyone out there, who could provide me with actual parameters, like frequency, current and equipment used?
Electronics Forum | Tue Dec 17 18:37:18 EST 2002 | davef
As a starting point, consider that these component leads may not be getting hot enough. Measure the temperature profile on the leads that do not solder well to be sure: * Heating and cooling ramps are within the paste supplier's recommendations. * C
Electronics Forum | Mon Dec 16 09:59:57 EST 2002 | blnorman
We had the same problem and solution with one of our components on one of our lines. Don't know for sure what the "weight" was that they used, but it did solve the problem. Since then the same line is looking a putting an adhesive on the part to ho
Electronics Forum | Mon Dec 23 18:06:38 EST 2002 | jersbo
Tried and True is counting your components if there is any indication of loss... this is a great TOPIC... unfortunately there are many ways to lose components. Feeder setup,problems with a feeder while in the machine(IE mylar problems or wrong step)
Electronics Forum | Mon Jan 20 06:57:41 EST 2003 | Doug
What methods are used to protect ESDS reeled components while loaded on a P&P machine? Is the tape & reel considered static shielding? What methods are used to protect ESDS components that are "in-process" on the P&P machine during PWB population?
Electronics Forum | Fri Jan 31 12:22:10 EST 2003 | TN
Many companies used the Fuji CP-4 and CP-6 chip shooters, these are good for the small components like resistors, caps, diodes, transistors and small IC's. If you have BGA, QFP or other larger odd components you will need to go with another type of
Electronics Forum | Wed Mar 05 22:37:11 EST 2003 | JOSEPH
Hello sir, The component is for surface mount reflow.It would dropped into the pwb slot during component placement if no support from underneath . RDGS
Electronics Forum | Thu Mar 20 03:40:13 EST 2003 | 9khonnei
some one can help me? I will need Picture of SMD component shape & Diamension for make trainning doccument.If has many kind of component is better for me. Thanks
Electronics Forum | Thu Mar 20 07:23:18 EST 2003 | davef
Consider dummy component suppliers, like: * Top Line http://www.topline.tv * Practical Components http://www.practicalcomponents.com