Electronics Forum | Thu Jun 05 19:19:13 EDT 2014 | FD
When you assign the feeder location, there is a default XY value that gets assigned to that location. When you teach the actual XY pick position you move away from that default position, and if the actual pick position is too far away from the defau
Electronics Forum | Fri Jun 06 02:35:06 EDT 2014 | maciejbilu
Got it. That make sense. Pick position is quite far from these "normal" one. I ignore the message (and press start button again) every time and the whole mounting process starts normally. JUKI mount every component assigned except one from 44mm feede
Electronics Forum | Wed May 21 15:13:56 EDT 2014 | wendynguyen234
Sarason, thank you very much for your support. There is an ISA interface board with just ribbon cable from window 95 PC to VME I/O DPRAM ver. 2 board in the same VME rack that has MVME-162-110 (CPU board), DSP, ADDA, AXIS & CONT boards. Do you think
Electronics Forum | Fri Jun 06 16:25:03 EDT 2014 | spitkis2
Component manufacturers subject their lots to thermal / reflow testing per IPC /JEDEC STD-020. This involves running the parts through an oven 3X with a peak above 260C. I am not certain if passives go through the same test (theoretically they shou
Electronics Forum | Wed Jun 18 03:19:34 EDT 2014 | edriansyah
Hi All. I'd like to do a little benchmark with you all regarding regarding the reflow speed. What is your highest reflow speed? My own experience is 8.0 m/minutes using a 10 zone reflow machine. Conditions: Mix boards (not only chip components, bu
Electronics Forum | Mon Jun 23 13:51:51 EDT 2014 | heath
Hello all, We have a My12 pick and place machine and have had limited success taping component strips to the tray wagon. Because we are a low volume/high mix business, we use a variety of packages. We are considering purchasing a strip feeder from
Electronics Forum | Fri Jul 04 07:11:43 EDT 2014 | padawanlinuxero
Hello We work with a TP9-4 and a MY12 both with tray wagons, I like a lot the tray wagon, for big components we use it, but like AVFM we build our own pallets, and some of them were big 3x30 array or even bigger all pallets were done in a ESD mater
Electronics Forum | Tue Jun 24 12:56:26 EDT 2014 | jmathis
Hello, As our company has begun doing an increase production of contract manufacturing I have seen more and more designs with the 0402 pad layouts that are smaller (.015 in width) than the component. Also there is only a .008 longer than the 0402 p
Electronics Forum | Mon Jun 30 03:21:38 EDT 2014 | sramos
Thanks Alexei for your advice. I consider mainly high-volume production with tape/reel feeders for most components and tray for big ICs. My ultimate goal is a cost estimation of the production activities. So departing from a parts-list, I need to est
Electronics Forum | Wed Jul 02 02:08:16 EDT 2014 | alexeis
Hi, What types of failures are discovered at specified? Is it the problems of deviations, angles or incorrect component form? Our customers use software tool QPlan to prepare placement programs (SMT SETUP). It includes simulation, automatic correcti
