Electronics Forum | Mon Jul 19 16:03:39 EDT 2010 | warwolf
Agreed, on some components we have seen a "brownish tint" after reflow it doesn’t happen on all of our resistors it only appears to be on the leads, and have also seen the purpleish tint on some other 2512 components
Electronics Forum | Fri Jul 23 02:17:26 EDT 2010 | joseph_smile
by viewing your posting i came to know this is solder ability issue which is because of marginable solder ability of PCB / components, just ensure that issue due to PCB or component . check the msl of of substrate / component. verify the baking r
Electronics Forum | Wed Aug 11 14:45:46 EDT 2010 | davef
Yes, it OK to mount axial PTH component as radial PTH, if that's what you're asking. * There are no rules for orientation. Pick something and stick to it. We like to be able to read the component value / orientation from the top towards the board.
Electronics Forum | Mon Mar 05 21:55:59 EST 2012 | vinitverma
Please describe the problem in a bit more detail like what is the size of the components in both the charges? It is possible that the size is a limitation here. What nozzles are used for all the 8 components in the component information?
Electronics Forum | Wed Nov 07 22:49:24 EST 2012 | davef
Bulk cassettes are not readily available because they're purchased by component suppliers, provided to their customers full of fly shit and when empty they're returned to the component supplier for refill. Try Topline or your bulk component supplier
Electronics Forum | Mon Nov 12 15:30:45 EST 2012 | rway
Bulk cassettes are not readily available because > they're purchased by component suppliers, > provided to their customers full of fly shit and > when empty they're returned to the component > supplier for refill. > > Try Topline or your bulk >
Electronics Forum | Sun Dec 08 09:59:39 EST 2013 | davef
Component fabricator is concerned about the temperature of the lead at the point where the lead enters the component body. So, if you sink temperature at that point, you will assure a lower chance of damaging the component.
Electronics Forum | Tue Dec 01 17:43:35 EST 2015 | barryg
Hi all, I was wondering if there are guidelines for how near components are to breakouts, and orientation of components near breakouts? Does IPC or other address this? We are sometimes approached with some crazy PCB layouts with multiple PCB's per ar
Electronics Forum | Wed Oct 19 18:44:47 EDT 2016 | chabscan
Good day I would like to know if the Quad 4C keeps a register of rejected components in a certain period of time, like " X components rejected from feeder Y" or something like that. Thank you so much
Electronics Forum | Tue Nov 15 03:32:31 EST 2016 | mark12
There is a lot of competition between Electronic Components Distributors. How can i select the best Electronic Components Distributor with ease?
