Electronics Forum: component and induced and bow (Page 1 of 1)

PCB assembly bow and twist

Electronics Forum | Thu Dec 26 12:12:55 EST 2013 | igorfo

Dear Friends, I need your help to understand requirements and measurement methods for bow and twist of assembled PCB (PCBA have and SMT and TH components). I already check all posts on the site but didn't found any related to my question answers.

Re: Bow and Twist of PCB's

Electronics Forum | Wed Aug 19 08:00:55 EDT 1998 | Earl Moon

| Hi there, | I'm actually facing a lot of trouble with PCB's presenting up to 3mm of bow /twist at reception i.e. before assembly. The PCB size is 220 by 230mm. The boards are to be assembeled SMD double sides with 05.mm pitch on both sides. In orde

Line release of post reflow AOI and AXI

Electronics Forum | Mon Sep 22 17:02:58 EDT 2008 | hegemon

You are on the right track Ismir. Essentially however, as the programmer of the machine, I am the one that creates the PCB with the errors to benchmark the settings for the machine. No secret lab though! :-) Easy enough for most any AOI machine to

Need low cost pick and place machine for limited production

Electronics Forum | Tue Aug 18 22:22:43 EDT 2009 | comatose

Assuming you want to run 8 hours a day and 5 days a week, you need a sustained throughput of 2.5k components per hour. With fine pitch, futzing around, setup, etc you should really look for machines rated in the 4k to 5k per hour range. That's not sc

  1  

component and induced and bow searches for Companies, Equipment, Machines, Suppliers & Information