Electronics Forum | Fri Dec 13 10:05:23 EST 2013 | igorfo
Dears, Could somebody advice is there exist requirements for storing(like humidity , temperature, etc) for PCBA (PCB with SMT components)
Electronics Forum | Wed Feb 09 21:41:27 EST 2000 | Dave F
Jack: You should use your components promptly. Don't store 'em, only bad things will happen to them. 1 You should store all your components, not just your SMD reeled components, so they are not damaged or their solderability decreased. Check the
Electronics Forum | Tue Jun 03 13:23:02 EDT 2014 | taiji
Also, for MSL 1 and 2, non sealed components, what should be the min/max storing temperatures?
Electronics Forum | Thu Apr 13 05:13:22 EDT 2000 | C.Long
Anyone have any ideas as how to track the amount of air exposure to SRAMS etc as thay move from stores onto the production floor. i am looking for ideas as how to track the exposure time from the time they are taken out of ther packaging to the time
Electronics Forum | Tue Jun 03 12:25:54 EDT 2014 | taiji
Hi Does any one know what is the min/max temp for material storing? I mean, for MSD once it is properly sealed in MBB, what will be the max temp to store in the ware house? Does any one know what is the standard for that? Thanks
Electronics Forum | Mon Jan 15 22:31:06 EST 2007 | davef
30% Rh
Electronics Forum | Thu May 10 10:27:29 EDT 2001 | davef
It depends ... * Components stored in a garage in Chiriqui,Panama will have a different shelf life than those store in a climate controlled room in Ayrshire, Scotland. * Components from a reputable supplier will likely have a different shelf life tha
Electronics Forum | Mon Sep 13 10:39:50 EDT 2004 | Marie
Suggest looking at the packaging,is it sufficient to prevent damage to the QFP?. What way are these components stored when received?.Are the reels stored in boxes or racks?.Storage in boxes may cause damage from stacking the reels on top of each oth
Electronics Forum | Tue Dec 31 10:17:12 EST 2019 | emeto
Let's stay away from the PCB and process for a while. This component is pre-tinned. What kind of solder? How is the component stored? I bet you that you can put just flux on the board and solder this part - have you tried? I think we should understan
Electronics Forum | Tue Jan 16 01:37:09 EST 2007 | grantp
Hi, If you need to get a humidity target, the best way is to run the air conditioning plant very cold, which will drop the moisture out of the air, and then you can reheat to the required temp, and install humidifiers to re humidify the air to the r