Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
Electronics Forum | Thu Apr 13 18:28:01 EDT 2000 | Michael Parker
Hello - I am currently evaluating uBGA rework and X-Ray inspection solutions. I would like any advice/warnings etc. regarding suppliers and equipment. I have already researched through the threads in this forum and have created a list of recommended
Electronics Forum | Thu May 14 10:00:14 EDT 2015 | swag
I like MpM personally - run forever and programming is easy and leads you through it. It's hard to miss a step of programming with MpM software. DEK's a little harder (for me) but still very nice controls. The pluses of DEK - DEK has a high freque
Electronics Forum | Sat Aug 15 07:56:16 EDT 1998 | Clyde F.
We need BGA rework station and x-ray inspector recently in urget case, Do you have any information to rework FPGA package and inspect them during processing. Thx for any information Best Regards, Stoney Tsai PACE just came out with a new s
Electronics Forum | Tue Aug 11 12:15:34 EDT 1998 | X-man
We need BGA rework station and x-ray inspector recently in urget case, Do you have any information to rework FPGA package and inspect them during processing. Thx for any information Best Regards, Stoney Tsai Stoney, Probably the best rewor
Electronics Forum | Thu Jan 27 05:36:37 EST 2011 | 15009
We use it and have had no issues on either oven. 1 Conceptronics, 1 Heller.
Electronics Forum | Mon Jun 16 13:57:48 EDT 2003 | James
Could anyone give me a basic profile temperature settings for a conceptronics 7 zone oven and speed? I have the first couple of zones ramped up to get to the soak temperatures. Is this correct or should I start out with low temperatures and graduall