Electronics Forum | Sun Sep 10 10:48:46 EDT 2023 | mekmat544
Hello, I have litle bit simply question. I have silver conductive glue in small syringe. Can you help my how should I mix this glue in syringe before using? Thank you. M.
Electronics Forum | Tue Sep 12 14:01:44 EDT 2023 | bryangomez
Thanks for the info..
Electronics Forum | Mon Sep 11 07:36:04 EDT 2023 | tommy_magyar
See attached snippet from a datasheet: Syringe 1. Twist and remove the cap from the syringe. Do not discard cap. 2. Measure 1 part by volume of A. 3. Measure 1 part by volume of B. 4. Dispense material on a mixing surface or container, and thoroughl
Electronics Forum | Mon Feb 28 04:10:07 EST 2005 | Rob
Hi Dave, Was planning on skipping the paste step & screen printing the adhesive straight onto the pad, then placing the component into the glue & curing. (Board has LEDs only) Regarding the lead-free HASL issue - not entirely sure on the board man
Electronics Forum | Tue Apr 04 02:46:39 EDT 2000 | George Verboven
We are looking for a way to cure conductive adhesive. I heard about curing times from 2 hours and more. But I also received information that curing can be done in 10 minutes at 120 C. Of course it also depends from the type of glue. But the question
Electronics Forum | Tue Aug 15 07:02:13 EDT 2000 | George Verboven
We are assembling SMD-Leds (Chip LED cl-220yg-c-ts)on flex foil with Electrical conductive glue (Matthey A1401). When we investigated these foils we found cracks between the conductive adhesive and round the edge of the Chip-leds. This cracks cause f
Electronics Forum | Tue Nov 09 12:41:31 EST 2004 | alanhayllar
What thermally conductive glues are available to glue Luxeon Lumiled parts down? Are single part glues without an activator available, suitable for screen printing or dispensing? Many thanks
Electronics Forum | Mon Jun 11 10:07:30 EDT 2007 | jdumont
Search the archives here for info. There is lots of posts on this. Short answer is Kapton isn't the best solution. Try aluminum tape or conductive glue if you don't feel comfortable soldering with high temp stuff.
Electronics Forum | Fri Jan 24 09:42:21 EST 2020 | emeto
The joint material looks like some kind of conductive glue. However, I can't tel from the picture what is this solder mask?
Electronics Forum | Thu Jul 20 17:07:49 EDT 2000 | JACKIE O'ROARK
Hello Bob, I am going to be working with a 5 Mil Flex circuit. There are 2 components to be placed on. I thought of using the conductive glue but after reading your message not recomending it, I am swayed againist it. What is the best way to place
