Electronics Forum | Fri May 18 10:43:32 EDT 2012 | davef
Umar Chapter 7 of IPC-HDBK-830, Guidelines for Design, Selection and Application of Conformal Coatings deals with compatibility of the different materials in the chain. Have you: * Tested your bare boards at incoming for cleanliness with your Omega
Electronics Forum | Tue Jul 31 10:16:59 EDT 2012 | silverbullet
We are in the process of revamping our conformal coating room. Presently, we have a C-740 Nordson Asymtek coating machine that sprays most of our boards with Dow Corning 2577. We are spending a lot of time masking boards and are thinking of upgrading
Electronics Forum | Sun Aug 13 00:15:58 EDT 2017 | deanm
We manufacture low volume, high reliability assemblies (class 3) that are conformal coated. Up until now we have been cleaning after SMT, then after through hole, then immediately prior to coating with test, formal inspection, etc. between cleaning p
Electronics Forum | Wed Sep 20 09:24:09 EDT 2017 | bstogsdill
Hi- I am attempting to determine if the "User Performance Inspections" on table 4-1 are required or are they just optional? Section 4 para 4.2 only refers to Qualification Inspection and Quality Conformance Inspections that are performed by the past
Electronics Forum | Wed Oct 06 08:49:36 EDT 1999 | Dave F
| | | | Can someone suggest what material I have to use to protect components by electrical discharge on ptfe based boards? | | | | It should have high resistivity, thermal stability (-40 +70 'C),perfect adherence on ptfe... | | | | Many tahnks | |
Electronics Forum | Fri Jul 24 13:04:55 EDT 1998 | Dave F
| Hey youse guyz... | We're finally getting our first real job at the start-up I'm working at. It's actually a pretty unique little board too. Simple as all get out, but unique. You're not gonna believe what this goes into...guess? (I bet ya' you'll
Electronics Forum | Fri Apr 12 17:22:47 EDT 2002 | davef
First, splitting hairs on parlance. * Conformal Coating. A thin electrically nonconductive protective coating that conforms to the configuration of the covered assembly to provide environmental and mechanical protection. * Solder Mask. Coating mate
Electronics Forum | Tue Sep 26 15:48:32 EDT 2000 | Dave Hulbert
I'm a bit confused about reading IPC-275 (I know I should have IPC-2221/2222) but I'm sure they are similar. Anyway, I am doing a: Military, less than 100V, non-conformal coated PCB, External Etch Sec 5.3.1.4 Edge Spacing.. (Pg 61) says use Tabl
Electronics Forum | Thu Sep 14 19:44:25 EDT 2000 | Brian W.
I cannot give references to papers, etc, but I can tell you from experience that High Impedance circuits and High Power RF circuits are not something to try no-clean on. For an aerospace customer, I had a circuit that any residue left between two pa
Electronics Forum | Tue Apr 11 20:23:19 EDT 2000 | Dave F
Ashok: You're still goin' down that ol' ESD road aren't ya bud? Why do you need the boards to be dry? Conformal coating? Hey wait a minute, are you one of those no-clean people? Er zis related to the Kapton tape res fandango? Anywho, be careful
