Electronics Forum | Mon Mar 28 23:44:51 EDT 2022 | glasscake
Looking into getting an upgrade for the Mirtec MV7-U I have currently. I like the machine and the software is good but the 18k machine registration fee and refusal to supply manuals, replacement parts, ext is rather annoying. What recommendations a
Electronics Forum | Wed May 11 17:25:22 EDT 2022 | SMTA-64387687
You've replaced the sensors and cleaned any grease residue inside the Midas head, and you're still getting this error. You can check the connector on the little board, on top of the Midas, where the flex cable plugs in. I don't remember, off the t
Electronics Forum | Fri Oct 28 13:48:30 EDT 2022 | proceng1
Well, I'm not sure about the "Trust me" button. I assume you can't tell it the part is smaller than it is because then vision won't accept it. I often add 10mm or so in X direction. In fact, when I measure the board, I just round the X up, becaus
Electronics Forum | Fri Oct 28 14:09:39 EDT 2022 | ttheis
Allowing a part to go over the board boundaries can cause collisions when boards are nested. The software on these machines has limitations but it is plenty capable and rooted in preventing physical damage to the machine. Once you are familiar with t
Electronics Forum | Thu Dec 22 17:59:39 EST 2022 | emanuel
Thanks Jeff, Yes, I will be glad to know which parts you replaced, at least it will give me an idea where to start looking. I also have a feeling that being the first node, the BGE9010C if not working properly may distort the CAN Bus signal. I even t
Electronics Forum | Thu Aug 31 04:56:44 EDT 2023 | auriga2001
I would start with the following possibilities and solutions: Add extra solder to the pads with a Camalot dispenser; or preformed solder slugs placed as an additional component if there is enough extra pad to attach it without interfering with compo
Electronics Forum | Thu Apr 05 12:25:17 EDT 2001 | Adam
The Solderballs are on the botton side of the board.The solderballs are concentrated around through hole edge connectors, which have a Tin/lead finish and have lead pitch of 2.5mm, on top of this, random solderballs are occuring around test points. T
Electronics Forum | Tue Dec 21 17:58:44 EST 1999 | Brian W.
When doing PIH processes, it is critical that you control the solder VOLUME, not the height. You must define the process, monitor it and control chart it to keep the paste volume consistent. You have do some careful engineering to determine how muc
Electronics Forum | Sat Sep 11 10:51:59 EDT 1999 | JohnW
Folk's, Been asked / told by my boss to look into our board prepping area for wave soldering and find another way of doing it. Thing's I'm looking at are: PCB Breakout - do you do it before or after wave Connector's that need to be pressed in due to
Electronics Forum | Wed Sep 08 21:36:14 EDT 1999 | kyung sam park
| I have a board that has surface mount on both sides . On this board is a 22pin connector which is the only thru-hole part.This part is located on the component side. I would like to reflow this part. Can this be done? If so, how can this be done?