Electronics Forum: connector and hdmi (Page 1 of 7)

Suggestions for small and handy connector for in-circuit program

Electronics Forum | Mon Oct 24 09:07:58 EDT 2016 | robl

Could you make up your own adaptor cable to connect to your programmer, then fit a small form connector like a Firewire on the edge of the PCB? It should only take up about 7x7mm of real estate as opposed to a 2.54mm 5x2 pin header 12.7 x 5.08, or a

Single-view camera in Topaz-X and connector type element

Electronics Forum | Wed Oct 23 13:01:11 EDT 2019 | compit

I have a single-view camera on a Topaz-X machine. When I define a connector type element - it displays messages like in attached files. If I change the type to IC - no problem. There is also no problem when "learning&quot

Suggestions for small and handy connector for in-circuit program

Electronics Forum | Mon Oct 24 05:43:52 EDT 2016 | zxcvb

I have many PCBs that use an AVR in SMD packaging, and since I frequently change the firmware in prototype boards, I'm trying to come with the best solution to program the AVR quickly and easily. The first approach was to have a standard header (2x5

Single-view camera in Topaz-X and connector type element

Electronics Forum | Sat Nov 09 20:11:43 EST 2019 | richardcargill

I suspect configuration too. From memory, only certain heads are assignable as 'Fine'. Changing this parameter in the component data to Standard or QFP will most likely cure this as any head will accept those two options

Single-view camera in Topaz-X and connector type element

Electronics Forum | Sun Nov 10 05:40:27 EST 2019 | compit

It turned out that only SF heads support "fine" mode, while FNC does not. Probably because above the FNC nozzle there is a "circle" rotating the nozzles, and in fine mode it can interfere with the reflection of the camera light - the element is lower

HDMI Connector poor contact

Electronics Forum | Tue Aug 10 05:32:42 EDT 2004 | praveen_madaan@jabil.com

Hi, Has any body experienced the problem of poor cotacts on HDMI connectors. The connectors pins are gold plated and we see some kind of white residue on the gold pins.How to check if this is a flux residue?We are using No Clean flux in wave solderin

Re: Paste-in_hole and CTE

Electronics Forum | Fri Jul 28 14:34:13 EDT 2000 | Gary Simbulan

Belive it or not, these boards were run through a Centech batch mode Vapor Phase machine. Single stage top side IR preheat. Vapor temp 218 C. Solder paste is an SN62 RMA.The boards were FR4 8 layer w/ solder mask, fairly conventional as might be e

LPMTF and EMTF

Electronics Forum | Wed Jan 15 07:28:15 EST 2003 | Jean-Philippe

Its not really an electromagnetic device, its just a feeder for connectors.

0402's and Gluing.............

Electronics Forum | Wed Feb 16 16:41:31 EST 2005 | Mrduckmann2000

Pallets will not work in this case because the wonderful designers put 0402's between the legs and all around the legs of the thru-hole connectors. There are 18 thru-hole connectors on this board and 200 - 0402's around them. The 0603's that are al

HDMI Connector poor contact

Electronics Forum | Tue Aug 10 09:21:15 EDT 2004 | davef

Aqueous cleaning solutions using saponifiers and surficants can sometimes be used to clean NC flux residues. Search the fine SMTnet Archive for background and supplier suggestions.

  1 2 3 4 5 6 7 Next

connector and hdmi searches for Companies, Equipment, Machines, Suppliers & Information