Electronics Forum | Thu Dec 24 10:07:42 EST 2009 | edwaterfall01
Get two connectors to fit the SMEMA 1 connectors on either end of the machine. Need only two wires on each connector going to momentary contact sw. Input is pins 1 & 2 to switch and output side is pins 3 & 4 to switch. If this doesn't work then ch
Electronics Forum | Tue May 22 11:08:12 EDT 2012 | patrickbruneel
It sound like this connector is a serious head sink which can be solved with more preheat or slower conveyer speed. It might also be a combination of the heat sinking capability of the connector together with encapsulated flux underneath the connecto
Electronics Forum | Wed Jan 15 12:10:22 EST 2020 | emeto
Avillaro, I don't have hands on experience with Vapor Phase equipment, but my guess is that it will work better for thick boards like yours. Trying another chemistry is a logical move. May be it is worth trying the fixture for connector flatness as n
Electronics Forum | Fri Oct 27 18:30:20 EDT 2000 | Dan Woodward
I can't help you with your soldering problem, but I wonder if a pressfit connector is an option for you. If this connector is available as pressfit, you can avoid the solder wave proces and associated problems. Write me if you are interested in more
Electronics Forum | Thu Dec 16 06:59:12 EST 1999 | Calvin Wong
Coplanarity also takes into consideration which is your reference plane. In the case of connectors, you can consider coplanarity between the highest and the lowest lead. Also, you can consider all the connector leads with reference to the connector
Electronics Forum | Thu Jul 08 03:33:33 EDT 1999 | Ron Lahat
Do you have experience with reflow process of a straddle mount connector on a 1.6 mm PCB ? Connector have more than 200 pins What is the process ? Thanks
Electronics Forum | Mon Oct 29 19:48:03 EST 2001 | davef
Sounds like the connector is not solderable. * Do they take solder when hand soldering? * Do they take solder when using a hotter flux than you normally use? * What flux are you using? * What are the materials used in fabricating these connector le
Electronics Forum | Wed Nov 14 10:07:49 EST 2001 | bartron
Air-Vac Engineering has nozzles for Mictor Connectors that work with their rework systems. They make removal and replacement of the connectors a snap.
Electronics Forum | Thu Aug 07 15:12:41 EDT 2003 | barryg
We are planning on placing a smt connector, the spec sheet calls out that "suction tape is added for smt suction". I am assuming that since this is a straight connector and I will be picking it up across where the pins are (male connector)that there
Electronics Forum | Fri Jan 16 17:28:10 EST 2004 | davef
Doesn't sound good. Is it only the connector that solders poorly? Tell us more about the solder, solder fracture, connector pins involved, and what not. Good any nice picture?
