Electronics Forum | Tue Feb 11 10:51:20 EST 2020 | slthomas
To predict whether or not a first pass part is going to come off during the second pass you need to calculate the ratio of weight/soldered surface area. According to a couple of different sources that I've dug up, maximum is around 44 grams/in.^2. I
Electronics Forum | Wed Sep 08 11:26:08 EDT 2021 | kumarb
Use a free cloud service like udrop or wetransfer. From your description, the plating is coming off the pogo pin itself ? Also, unless you absolutely cannot sub the part, consider the following vendor - have others as well that service the 'pogo p
Electronics Forum | Wed Mar 16 06:46:59 EST 2005 | -=Verm=-
Hi lads long time no post... I have an issue with a PCB, its a PCI card that we manufacture for a customer of ours. The customer is seeing a problem with contact on a PCI card with the motherboard, the PCI card is removed from the board wiped and th
Electronics Forum | Tue Sep 29 21:39:07 EDT 2020 | kylehunter
Hi, We are currently working on a board that has 3x 50-pin THT at 1.27mm pitch each. This is too small for us to be able to consistently do on our selective solder. We are instead considering pin in paste. The connector we are using can be spec'd at
Electronics Forum | Wed Oct 25 13:42:32 EDT 2000 | Chris McDonald
I was wondering IF anybody has has success wave soldering a 50 (2 rows of 25) pin 0.050" pitch thru-hole connector. I seem to be getting alot of bridging no matter what I do. Is there a design spec for the size and shape of pads? The pads on the pcb
Electronics Forum | Thu Jul 27 12:09:41 EDT 2000 | JohnW
Jason, where on the board is your connector?, front / back / middle? and where it on the PCB that you don't have issues with? Thief pad's are basically dummy pad's taht you have after the last set of pin's on the component are are used to draw the
Electronics Forum | Mon Jun 14 07:41:47 EDT 1999 | Vinesh gandhi
Dear All, We are having a big debate over what is the industry standard in DPPM on the wave sodlering process. is a DPPM of about 800 satisfactory. As per our big bosses it should not be more than 50 DPPM. Is the figure realistic. We are typicall
Electronics Forum | Thu Apr 22 16:54:28 EDT 1999 | John W
| I need to know if there are any special component pad designs that need to be considered when evaluating paste-in-hole? We have a few through hole connectors that are good candidates to place pre reflow. Does anyone have sugguestions. | Thanks |
Electronics Forum | Tue Feb 23 16:55:43 EST 1999 | Joe Zuchowski
| who do you like to go to as a source of | caps, resistors, ICs, DIPs, connectors | | I'm looking for distributors. | | For I.C.'s I have had good luck with Future/FAI, Arrow, Western Resources, and Vista Mfg. Co. in K.C., Classic, Insight Cap
Electronics Forum | Thu Nov 19 10:24:14 EST 1998 | Brian Co nner
Currently, I am having problems with a AMP Mictor connector at the wave process. These connectors have both SMT leads(topside) and thru-hole leads. Even though we have re-designed the board for via issues. We still see some of the SMT leads re-fl