Electronics Forum | Wed Feb 09 12:02:15 EST 2000 | Wolfgang Busko
Sal: If it�s not the PCB, what about the connector itself ? Is it from a different production lot with some unregularities ( dimensions, tolerances, pin alignment, material weakness)? How about handling, storage, shipping causes ? Could it be a tooli
Electronics Forum | Sun Feb 13 19:57:59 EST 2000 | park kyung sam
hi. pascal your problem is mine. sorry. i have no experience about m/c for pihr. we use woman for stick pin ,sme connector after mounter. we also consider m/c just like you. what i want to let you know is that http://www.celtronix.com. bye
Electronics Forum | Wed Jun 28 07:45:39 EDT 2000 | Wolfgang Busko
Hi Allan, I can�t help with literature on that topic but we have great success with solder thiefs to prevent bridging with 2mm pitch THT-connector. We added just blind pads of the same size at the end of each row similar to what you can do with SMD
Electronics Forum | Tue May 23 22:23:20 EDT 2000 | JAK
Hi all, I'm would like to try intrusive reflow (pin in paste, paste in hole, etc.) on a connector using WS-609 solder paste (halide free, water-washable). I'm concerned about entrapped flux in the barrel of the solder joints. If there were to be e
Electronics Forum | Tue May 23 22:21:13 EDT 2000 | JAK
Hi all, I'm would like to try intrusive reflow (pin in paste, paste in hole, etc.) on a connector using WS-609 solder paste (halide free, water-washable). I'm concerned about entrapped flux in the barrel of the solder joints. If there were to be e
Electronics Forum | Thu Jul 20 14:31:20 EDT 2000 | Bob Willis
The process is not that difficult so have a go as soon as possible. Take a board wipe some paste on a board stick the part in and run it through the reflow process. Don�t worry about balling just see what you get first, that what I did first ! The m
Electronics Forum | Mon May 14 18:31:20 EDT 2001 | genny
The experiment was to determine insertions from a > gold plated board into a connector. Same > thickness boards (0.062"), with 100 m base > nickel. � 100m gold =_ 500 insertions � 50 m > gold =_ 300 insertions � 30 m gold =_ 50 to 75 > insertio
Electronics Forum | Wed May 16 07:08:23 EDT 2001 | Michael Fogel
We are using press fit connector for some time without any particular visible problems, but still we need some kind of workmanship standard as a general guideline of what is wrong, acceptable and preferred levels for this job. Can someone direct me w
Electronics Forum | Mon May 21 03:20:16 EDT 2001 | Abbas Izad
you can use IPC and Compact PCI standards for guideline then it depends on what kind of connector you want to pressfit. each supplier has its own design on pressfit pins like "needle eye", "baby H" etc... It is also importand to use proper equipement
Electronics Forum | Tue Jun 12 10:13:10 EDT 2001 | techment
Thank you, Mr Dave. Specifically, there are tiny balls spreading on the boards ( on top of solder resists, and not encapsulated). They are not near to any land/pad or connector. I do not think they post any electrical problem. They are quite far away