Electronics Forum | Sun May 03 17:58:22 EDT 2009 | cusackmusic
I just bought a used Contact Systems CS-400D, and it does not have manuals. Does anybody have an extra set? Also, I haven't seen the machine yet, but I am wondering about getting PC software to do the programming and off-line programming. Who is a
Electronics Forum | Mon May 04 14:31:19 EDT 2009 | markgray
I am trying to figure out a strange problem on our machine. When I turn on the component verifier fuction the pick in the feeder offsets to the right 3-4mils. This is causing mispicks on 0805 and 0603 parts. When I turn off the verifier the pick is c
Electronics Forum | Mon May 03 20:54:06 EDT 2010 | aungthura
Thanks Josh for your kind advice. Yes, we have some contacts of Rehm vapor system.However, we didn't know about cost of galden what you mentioned.It is a good point and has been kept as a note and Electrolytics in Vapor phase,too. Hope you can share
Electronics Forum | Tue Aug 31 09:58:33 EDT 2010 | cardinal
Hello, I am looking for someone who can do complete installatin and training on a 2005 vintage SPEA 4040 flying probe system. We are willing to pay top dollar for this service; please contact me if you have interest in this job. Future opportuni
Electronics Forum | Fri Dec 21 16:34:28 EST 2012 | bdamico
Hello All, Some of the issues reported in this thread sound similar to those commonly experienced with network delays. A very simple way to determine if this is indeed the case is to run directly off of the system hard drive versus a network hard d
Electronics Forum | Sat Dec 01 14:08:52 EST 2012 | ghayurshah
GF-B-HT 2) ELPRO Manual Pick and place > MAN32 + vision system 3) Ren Thang Manual Stencil printer > STP550 Can anyone quote the best price for the above? We are also considering to buy in used condition. Please contact if you have any of the above
Electronics Forum | Mon Feb 11 13:53:56 EST 2013 | vickt
Dman, This and many other previously experienced field issues can be easily found and recified 24/7 if you reference the UIC online knowledgebase. If you do not already have access, please contact UIC tech support at GSMTechs@uic.com to register. I h
Electronics Forum | Thu Dec 19 08:26:19 EST 2013 | dekhead
Are both machines running the same type of computer (Advantech Computer w/P3 1G CPU probable)? if not possible problem with system software incompatibility. Contact me directly, I may be able to assist. www.dekhead.com
Electronics Forum | Wed Feb 13 20:27:02 EST 2019 | SMTA-Chris
We’ve done similar projects. FR-811 with camera system for alignment. More cost effective than split vision. Bottom heat uses solid surface for contact heating similar to heating microwave module chassis. Our rep can arrange a demo if you haven’t
Electronics Forum | Mon Feb 10 17:27:19 EST 2020 | SMTA-Alex
I used the older MYCam s/w to program the MY600. We switched to FactoryLogix for the MY700 printer. By the way, Aegis also supports Mycronic's Factorylogix installations. You can contact them about the crashes. It can, also, be from Windows. Sometime
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400