Electronics Forum | Fri Sep 24 12:02:57 EDT 2004 | Frank
Yes, I can see your problem, the nozzle makes only good contact in the center and so the ends don't make good contact. The ends tend to curl up during reflow. There were two suggestions to solve this. 1) Let the operator push down the labels befor
Electronics Forum | Fri Oct 01 04:31:08 EDT 2004 | pioneertechnology
Hi Marcel I bought four BTU ovens a couple of years ago at auction and had the same problem where two of the ovens had software and two did not. I loaded in the software I had onto the two ovens and this only partially worked as the software is con
Electronics Forum | Tue Feb 07 11:26:40 EST 2006 | Cal Kolokoy
At the wave, you should collect data on the critical process parameters. The cliche being, it's better to control your process via SPC versus performing SPC on defect data. Perform a DoE to determine which variable interactions have the greatest eff
Electronics Forum | Mon Jun 26 10:58:16 EDT 2006 | J.E.M.
Question for anyone using panasonic super thin surface mount light touch switches EVQ-PLDA15. The above part has a recommended land pattern with two gnd pads.There is a little tab on each side of the part that i assume is suspose to make contact wit
Electronics Forum | Thu Sep 07 09:04:24 EDT 2006 | Doug Eidle
Hi, First off, I am the Pre Owned Equip. Business Mgr. for Speedline Technologies. We have a factory Renewed (our enhanced refurbishment process) available. You can contact your local Speedline MPM Rep for price and information. If board warp is
Electronics Forum | Thu Nov 08 16:02:28 EST 2007 | ck_the_flip
We've got lots of connectors at my place of employment like this. What I do is... I run these "slower than molasses in January" - we're talkin' 2 Ft/Min. conveyor speeds. Obviously this will have an effect on your thermal profile so compensate acco
Electronics Forum | Sun Mar 01 01:22:45 EST 2015 | thompson
Hello Joe, I am Thompson from China. I know this small trade company Leadsmt who is not making the Pick and place machine and also the reflow oven. All the machines is taken from other small Chinese manufacturers.While you may not visit his factory,
Electronics Forum | Fri Feb 17 07:23:29 EST 2017 | sevenfortyone
I'm a PCB designer working on a board that has a rubber keypad with control buttons mounted to it. The PCB contains the corresponding contact patterns for the buttons - a typical interlocking finger pattern. In the past when I've encountered this
Electronics Forum | Tue Feb 21 01:32:49 EST 2017 | soldertraining
Looking for advice on soldering lead free paste to a board with very heavy gold plating, In my opinion, Gold contact surfaces are often used on circuit boards with membrane switches which is a choice of technology for industrial, commercial and consu
Electronics Forum | Tue Jul 25 13:40:04 EDT 2017 | davegoad
I have some CERSOT-23 transistor packages with castellated terminals. The 4th lead (drain castellation) is electrically connected to the top of the device by the castellation. The castellation goes up the ceramic body and contacts the metal package