Electronics Forum | Thu Aug 01 16:28:17 EDT 2013 | jimmyboz
Does anyone have info on the "Cycle Steel" > function on the Fuji XP141 machines. I am new to > the industry and have not had any luck finding > information on it. I talked to Fuji and they > just tell me to leave it on, it will help with > pl
Electronics Forum | Tue Aug 13 06:23:51 EDT 2013 | mccabekev
We are running a Heller 1707 EXL reflow oven, but we have a temperature variation across the board. When the oven first comes up to temperature, the centre of the board is 10degC hotter than the inside rail which is a further 10degC hotter than the
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Fri Aug 30 21:54:14 EDT 2013 | nophsem
Well, the error occurs with Mod Code 56 (dispenser enable). Head # 1 has installed this accessory, but we use it very little and it wasn't this time. I probed setting 0,1,2 and 3. I downloaded Mod Codes from controller to assembler, then the error b
Electronics Forum | Mon Sep 09 12:00:01 EDT 2013 | proteus
I have a 208 pin QFP that due to manufacture obsolescence I have to get them form the broker market. I've had several issues with the parts including; bent leads, leads that don't take solder very well, co-planarity problems, and DOA fallout after a
Electronics Forum | Sat Sep 14 23:45:44 EDT 2013 | jandon
How many operator/technician/engineer do you recommend for following SMT assembly line to achieve good uptime and smoothly running quality inspection, NPI process, tehcnical support and maintenance at the same time: - Single shift, 8 hours/day - Pri
Electronics Forum | Fri Sep 27 21:01:52 EDT 2013 | marcelorotofrance
Hi everybody This week I was creating a new program by means of saving a successfull existing one under a new name with "UTILITIES/Data Base Utilities/Select/Copy/Delete Board Program" on CC7.54, to seize useful parts without having to teach them aga
Electronics Forum | Wed Oct 16 09:55:24 EDT 2013 | markhoch
Thanks guys. I can see the benefit as a CM, when you have no control over the Parts/PCBs that come in the back door. In my previous job at a CM I did often have product coming in the back door that did appear to have exceeded its shelf life, and hav
Electronics Forum | Fri Nov 22 16:55:30 EST 2013 | hegemon
Head and Pillow defects beneath a BGA are difficult to find, no matter what the equipment is on hand. Since you do not appear to have access to tools that would help you, or $$ to purchase said tools, I might recommend that you use an outside source
Electronics Forum | Thu Jan 02 04:56:38 EST 2014 | bobpan
Here is a couple of things to look at: 1. Make sure the boards are plugged into the correct position. Also just leave out the transport card to see if its hanging up the machine. The transport board should be the board all the way to the right. 2. M