Electronics Forum | Wed Apr 02 05:31:45 EDT 2014 | jdumont
We have four or five of these guys scattered around our 40,000sqft plant spraying DI water. They have a not so accurate built in humidistat but its good enough and they aren't that expensive for upfront cost. Just lube the packing washers in the gun
Electronics Forum | Tue Feb 24 16:11:15 EST 2015 | emeto
I assume you have a part number system. If so, you should kit the reel with less parts first from the same part number. If you don't use part number system, then you probably have components sorted by value and size, which should lead to the same pri
Electronics Forum | Wed Feb 25 11:42:29 EST 2015 | emeto
What software do you use to track your parts? We use Manex - it is not perfect but still gives you the opportunity to track parts/jobs relations. For example I know in each moment one particular part goes to 5 currently open jobs. You should explore
Electronics Forum | Tue Jun 23 13:58:44 EDT 2015 | alexeis
Hi, We have developed different software systems for the field that you are talking. You can find information about our solutions (such as Setup Center, QLine etc) on our website: http://www.proventustech.com. Also, feel free to send me an email: al
Electronics Forum | Tue Jan 21 11:11:07 EST 2003 | slthomas
OK, so the issue is with the variability of the alloys on the soldering surfaces and the subsequent variability of reflow temps. Sounds reasonable (actually obvious, now that I think about it), especially on the component side. We only use HASL fin
Electronics Forum | Fri Nov 11 04:40:18 EST 2005 | pavel_murtishev
Good day, First of all used solder paste should be placed in special container. It should be kept separately from �fresh� solder paste from the same jar. Limit paste usage period after opening the jar according to manufacturer�s specification. When
Electronics Forum | Tue Aug 23 12:58:16 EDT 2011 | emeto
Hello everyone, we are contract manufacturer and I am wondering if we can save some time from inspection and verification. We will usually inspect the bare boards, then, verify program to BOM, then feeders to BOM and Feeders to program,then paste ins
Electronics Forum | Fri Sep 02 11:26:50 EDT 2011 | steffenr
Overkill for sure! Program to BOM: Shouldn't have to verify the program to the BOM once it's been verified unless there is a change. Feeder to BOM" There should be some type of instruction that specifies that part goes on what feeder and where the
Electronics Forum | Wed Mar 14 16:10:38 EDT 2012 | cobham1
We need to develop a method of putting solder paste on a stencil then putting the unused part back into the refrig. Reason we are thinking of this method is because we only run circuit boards twice a week. I dont want to waste entire jar of paste bec
Electronics Forum | Tue Feb 24 15:52:58 EST 2015 | swiese242
We currently have around 20k+ components in stock. I would like to have some opinions on creating a more lean manufacturing system. We check stock in our system and then order parts. Most of time leading to employees looking for parts, or shorts. We
.gif)
