Electronics Forum | Tue Oct 26 19:53:38 EDT 2004 | Frank
That PM460 is quite old. It would be not be the least bit surprising if either of those controller boards in the PC were not functioning. They are what 15+ years old? I would contact the US service dept. 919-460-0111, and ask to speak with Rick.
Electronics Forum | Tue Jan 11 10:02:43 EST 2005 | jdumont
Good day all, we have an evaporator for our PCB washer that has been fine up until recently. Everytime we run it, it boils over and makes a HUGE mess of everything. Any suggestions as to why this could be happening? Is it possible the temp controller
Electronics Forum | Wed Jan 26 08:27:12 EST 2005 | pr
I am using the AVK and am VERY pleased with it. One thing to keep in mind is incoming tape and reel has to be pretty exact. The parts are going into a feeder and if the width varies too much you'll have problems. After we got control of Tape and reel
Electronics Forum | Mon Jan 31 07:01:56 EST 2005 | pjc
These guys http://www.cetaq-americas.com/index.shtml have the CmController that can do the measurement to back up the p&p vendor's claim. A CpK of 1.33 ain't bad. Would like to see 2.0. The picking is critical too. Ask vendors for pick accuracy and
Electronics Forum | Mon Feb 14 17:36:37 EST 2005 | griinder
WE ARE USING MIRAE MX240. ON THIS MACHINE, THE FEEDER ADVANCE AND THE FEEDER PITCH IS CONTROLLED BY THE MACHINE/SOFTWARE AS OPPOSED TO THE FEEDER ITSELF. OUR SELECTIONS FOR 24MM FDDERS ARE 4,8,12, 16, AND 24MM.I WAS WONDERING IF THE 20MM PITCH WAS UN
Electronics Forum | Sat Feb 19 09:26:19 EST 2005 | davef
Your customer asks a reasonable question. How do you know that your: * Paste has not dried? * Stencil aperatures have not become clogged? * On and on ... Some agrue that printing is the most critical process and that it drives all down-stream failu
Electronics Forum | Sun Feb 27 13:42:44 EST 2005 | pmdeuel
So true, We had paste flux supplied to us from Alpha metals. It was the same as used in the solder paste. The major problem we noted was the in ability to control the ratio of paste to flux resulting in lots of voids. When we mixed enough to get the
Electronics Forum | Mon May 16 17:58:54 EDT 2005 | ??
Are you sure you dont mean quad 100. The software for a quad 1000 (which was a samsung machine) was not available on disks or to install......I dont recall ever seeing it on a disk. If its a quad 100, you would need version cc5.6d central controller
Electronics Forum | Thu Feb 24 13:52:16 EST 2005 | deyo
I have a quad vmp20b benchtop printer that keeps blowing out the table up\down control FETS. Anybody have any idea what component is before or after these fets that could be causing this? I metered all the surrounding components nothing was out of t
Electronics Forum | Mon Mar 14 10:38:02 EST 2005 | ???
Are you absolutely sure that you changed the x-y ribbon cables....the z is controlled through those cables and almost all the time one of the cables has an intermittent open. I think there is a small card in the top of the machine (under the black co
