Electronics Forum | Mon Oct 05 11:51:55 EDT 2009 | mikesewell
We managed to run a ~30" board on an Assembleon Topaz/Emerald with only an 18" capacity by getting creative with the board sensors/clamping and running it as two programs, the manufacturer actually helped us through the workaround. I think we hand
Electronics Forum | Thu Nov 12 06:38:00 EST 2009 | nagesh
Dear All, I have a problem with the BTU-Paragon 150 10 Zone Reflow Oven. Am not able to lift the HOOD using the buttons on the Main control panel. I have checked the Lift hood switch & Ok. Pls. advice / Suggest. Thx in advance for all your sincere
Electronics Forum | Wed Nov 18 13:00:16 EST 2009 | evertonsanches
Dear All, > > I have a problem with the > BTU-Paragon 150 10 Zone Reflow Oven. Am not able > to lift the HOOD using the buttons on the Main > control panel. I have checked the Lift hood > switch & Ok. Pls. advice / Suggest. > > Thx in > advanc
Electronics Forum | Tue Nov 17 01:05:26 EST 2009 | 89jeong
To monitor the reflow profile is very important. We are doing profile every week(Monday). Out customer asked us daily check at first. We checked daily but we changed the checking period from daily to weekly after discussing about it with our customer
Electronics Forum | Thu Jan 07 15:28:52 EST 2010 | cbart
did the boards get built by hand or via smt process (through reflow oven)? Someone asked earlier if some one touched up the adjacent joint. The answer to that question is yes. Look at how the solder tails off the smt pad away from that joint! I suspe
Electronics Forum | Wed Feb 17 17:15:17 EST 2010 | jax
Did you just change anything on the Exhaust?... even if the change was adding something else to the main exhaust trunk, if you don't have each item seperated. Although CFM changes should not effect the Blower Speeds or the Zone stablizing time, since
Electronics Forum | Thu Feb 18 14:34:39 EST 2010 | jlawson
I have also seen on Heller ovens (even new ones EXL series) cross profile temperature differences over their spec of +/- 3 deg C, sometimes up to 7-10 deg C, 200-230mm from fixed rail. This can cause funny issues , profiling can cover this up and not
Electronics Forum | Tue Jun 08 19:13:03 EDT 2010 | vmorina
Hi Vee, I thank you very much for the reply,and yes everything is ROHS. I am reading over the manual and looking at the differences between them. I also have a questions for you regarding stencils for BGA and other types of packages. Do you know any
Electronics Forum | Wed Jun 09 11:41:25 EDT 2010 | smtmax
Hi Danny, I would suggest a laser-cut stencils w/ anti static polymer film. For more information on the stencil you should consider engineering lab. They provide high quality stencil for a reasonable price. If you can find a laser-cut stencil for a
Electronics Forum | Thu Jun 10 20:39:02 EDT 2010 | ada
T962's have a great reputation for cold spots, non-RoHS capable, and catching on fire. however, one can't argue that they are quite inexpensive! The T200's can be had for ~$2k and are apparently not too bad. See this thread for some first hand accou