Electronics Forum | Thu Nov 10 16:19:42 EST 2005 | 1st Article
Dear Sumote, I would suggest DESCO ESD safe heat gloves, we are using them at our facility, these gloves have a polyester exterior fabric with conductive fibers to ensure static protection. Inner lining constructed of material for use in heat of 200�
Electronics Forum | Wed Dec 10 13:26:03 EST 2014 | spoiltforchoice
I don't have one, but a lot of ovens of this vintage are on the market because they DO NOT cope well with lead free processes. There is one of these on eBay right now and it even says ROHS is right at the limit of what it can just about manage so thi
Electronics Forum | Thu Dec 11 13:49:48 EST 2014 | emeto
If you have a chance ask them to bring in one of your products(take board, stencil and some heavy part on the PCB that will absorb a lot of heat). They should be able to screen(even manually) it for you, hand place the part and send it through the ov
Electronics Forum | Fri Jan 04 09:34:45 EST 2019 | ameenullakhan
Hi , thanks.. yes you are right.Its bot and top side. Decreasing the lower heaters and increasing the top heaters for secondary side. will this matter in convection reflow ovens. Since the heat at the end will get equally distributed. We were s
Electronics Forum | Thu May 11 15:07:42 EDT 2000 | Finepitch Services
I assume your oven has a "board width" setting for every board and the conveyor width is automatically adjusted as soon as you select the profile/recipe... For the double sided reflow boards, I would set the width 1 inch (or another rounded amount)
Electronics Forum | Thu Dec 11 09:15:06 EST 2014 | sreejhu
Hello Sir, Thanks for your reply. i just got a mail from the DIMA service group and they said the Oven setting is as follows: Max temp settings in each zone (Which is not the temperature on your product, but close to where the air flow comes out of
Electronics Forum | Mon Nov 17 18:40:10 EST 2003 | Ray Wilson
Advanced electronic assembly convection reflow ovens include a variety of options for cooling product after reflow. The Electrovert Omniflo series ovens include options for internal or external cooling systems. What are the pros and cons of utilizin
Electronics Forum | Mon Jun 07 17:36:19 EDT 2010 | vmorina
Greetings SMT folks, My name is Danny, I am looking to purchase a low-medium/prototype reflow soldering machine. I would like to have your opinions for which vendor I should go for and model. I have been looking at the convection heating reflow sold
Electronics Forum | Tue Sep 16 10:14:03 EDT 2003 | mantis
James, Could it be the convection in the reflow oven itself.Maybe somebody has increased the air flow or convection rate. I have seen an issue with an sot23 blowing off pad in a BTU paragon due to air flow in air curtains being too high. Hope this h
Electronics Forum | Thu Feb 17 01:58:29 EST 2000 | Roni Haviv
Hi Richard, You can use "MOLE" profiler, an accelent profiling tool. Good luck, Roni