Electronics Forum | Mon Mar 11 07:05:06 EDT 2024 | klauss
while conveyor goes down to relaese pcb, some big compoments are swinging left or right due to high down speed of the conveyor. is there any way to decrease the speed?
Electronics Forum | Mon Apr 29 01:29:29 EDT 2013 | aemery
If your current problem with the conveyor speed was caused by the SMEMA issue, maybe you have a Board #1 problem. The SMEMA communicates to the computer through Board #1. The input signal from the speed encoder and the output analog voltage to the
Electronics Forum | Tue Mar 28 04:49:39 EST 2006 | AR
All's well that end's well: I replaced the Dart speed controller card and the problem disappeared completely. But no harm in giving the chains and the rails a thorough scrub although they weren't the culprit in this case. Many thanks to everyone for
Electronics Forum | Mon Jan 15 19:21:08 EST 2007 | SWAG
Not sure if this has any bearing on the problem but did you check to see that T2 and T3 are jumped on the speed control board per the first note in the prodedure?
Electronics Forum | Mon Jan 15 13:49:09 EST 2007 | leemeyer
Hello all, I am having some trouble with the conveyor speed on an Omniflow 7 reflow oven. Recent profiling showed that the conveyor was running to slow so I calibrated the speed using the instructions in the manual. After calibration there was no ch
Electronics Forum | Tue Mar 05 09:11:11 EST 2019 | slayervv
The conveyor on our Topaz runs for about a second then stops. Turning on conveyor manually does the same thing. While conveyor is turned on manually, disconnecting and reconnecting 208AC at connection board starts the conveyor for a second then it
Electronics Forum | Mon Mar 20 06:21:42 EST 2006 | AR
Have a problem with Omniflo 5 (-97 vintage) pin chain conveyor. Occasionally the conveyor stops for a second or two, then makes a slight jerk, then stops again, makes a jerk etc. Then suddenly the problem goes away only to return next day (we switch
Electronics Forum | Wed Apr 24 12:54:36 EDT 2013 | smtventasmex
Hi i working now on electrovert omniflow 10 tha deos not control the speed of the conveyor on the sofware, i did change the encoder but this ones continue failing, this fail start because we have a short cut on smemma wire, any one have experience wi
Electronics Forum | Thu Apr 19 07:42:53 EDT 2012 | leemeyer
I just purchased a used Universal Instruments Boardflo conveyor model 5363. It looked like it would be perfect to connect 2 of my Quad 4c machines in line. it came with a SMPI to Smema converter box. I connected the box S1PL and S2PL to what I beleiv
Electronics Forum | Tue Sep 01 11:12:18 EDT 2015 | zombee
Problem is solved! There wasn't voltage on motor inputs (only 5-10V AC) when the motor connected correctly, but was ~210V AC without motor. Firstly, I exchanged the motor speed control relay (Panasonic G-series type), but the result was same. (the a
.gif)
