Electronics Forum | Tue Oct 13 10:18:18 EDT 1998 | amir faris
Dear leaders of SMTnet i am amechanical engineer work at BHIT (Benha higher institute of technology )in Benha , egypt. I have a new search in electronics .It is Cooling of elctronic equipments using jet of air but realy i donot know a lot about the f
Electronics Forum | Mon May 10 13:55:22 EDT 1999 | Deon Nungaray
| Can anyone tell me what the recommended "typical" cooling rates are after reflow? Are the cooling rates considered as critical to control as the heating rates and why/why not? | I do not think there is a "typical" post reflow cooling rate out ther
Electronics Forum | Mon May 10 10:08:16 EDT 1999 | Rich Taylor
Can anyone tell me what the recommended "typical" cooling rates are after reflow? Are the cooling rates considered as critical to control as the heating rates and why/why not?
Electronics Forum | Fri Feb 03 15:40:39 EST 2006 | chrisgriffin
Hello, I am looking for replacement cooling fans for the BTU oven cooling zone. The oven is a P98 model. BTU is back ordered, and I can't wait. Does anyone have any extras to sell, or know of an alternate source? Any help is greatly appreciated.
Electronics Forum | Thu Feb 09 09:36:55 EST 2006 | aj
All, I would like to find out if it is possible to adjust the cooling rate on a Conceptronic Reflow Oven Model HVN70. We do not use Nitrogen and the Cooloing system is Genesis GCM-1. From profiling it seems to be cooling too quickly. Any replies a
Electronics Forum | Wed Jul 13 07:46:22 EDT 2005 | ajaydoshi
We have BTU oven150 paragon. Want to buy new cooling fan with mettal blade Part number is 5061761. Any supplier recommdation. Parts from BTU very expensive ajay
Electronics Forum | Thu Jul 14 06:47:22 EDT 2005 | Nirmal
U want to buy new cooling fan with mettal blade this is supplier number pls contact him for more detail thks.. Eightronics Plus SDN.BHD ( Magen 0124896854/0124107169 )
Electronics Forum | Thu Feb 09 09:45:50 EST 2006 | PWH
I'm not familiar with the HVN70 programming but our conceptronic oven reacts well to adjusting the cooling fan speed at the end of the oven. However, TAL will likely be affected substantially by changing fan speed.
Electronics Forum | Wed May 12 10:29:25 EDT 1999 | Timothy O'Neill
| | | Can anyone tell me what the recommended "typical" cooling rates are after reflow? Are the cooling rates considered as critical to control as the heating rates and why/why not? | | | I do not think there is a "typical" post reflow cooling rate
