Electronics Forum | Tue Aug 18 17:40:52 EDT 2009 | jlawson
Is the mechanics ok with the raising and lowering into the vapour ie no small movements that could be moving the part ? Most Vapour Machines have a lower and raise mechanisim so movemnt of parts can happen if not smooth, especially when coming out o
Electronics Forum | Wed Jun 16 15:39:15 EDT 2010 | mikesewell
Keep in mind you'll still need to preheat the assembly to properly activate the flux/drive off volatiles in the paste. Perhaps a convection toaster oven... Add some cooling coils and a freeboard/tube to the top of your pasta cooker or turkey fryer t
Electronics Forum | Fri Jun 25 13:56:01 EDT 2010 | tate350
Consider using wavesolder pallets that keep the board flat during wave. Keep the board in the pallet after wave until it cools down a bit then remove it.
Electronics Forum | Fri Sep 17 17:00:39 EDT 2010 | AL
we are using convection ovens and we face the issue when changing from Pb to RoHS but also even when change top side to bottom side if the diference on the profiles needs to go from a high temp to low, we are opening the hood but we would like not to
Electronics Forum | Fri Sep 24 04:02:39 EDT 2010 | emmanueldavid
@Sachu: Thank You. Well AL, hope You get the real but to compromise on the time. Many Thanks, David, India.
Electronics Forum | Fri Dec 17 02:52:40 EST 2010 | Jacki
Hi Dave Thanks however the Forums you mentioned isn't enough to solve my proble, PCB warpage after cooling down. Hope someone can advise me more.
Electronics Forum | Mon Jan 03 09:36:02 EST 2011 | markhoch
There is a fan on the upper rear of the machine that has to be running for the machine to initialize. i suggest lifting open the top and check the operation of the cooling fans.
Electronics Forum | Fri Jan 14 16:55:31 EST 2011 | tombstonesmt
On our Pilarhouse Jade we use nitrogen to cool the belt that drives our solder pump as well as keep the amount of oxygen to a minimum in our solder pot to reduce dross.
Electronics Forum | Mon Dec 05 12:07:18 EST 2011 | pszumny
Hi, If somebody knows Real power consumtion of Heller 1707 with bottom heating, no active cooling ? I plan buy it. Thanks in advance.
Electronics Forum | Fri Jan 06 13:36:38 EST 2012 | cyber_wolf
What does Vitronics say ? I personally wouldn't be too concerned about it. What do the flux catchers look like in the cooling section ?