Electronics Forum | Mon Jul 26 21:56:53 EDT 2004 | pdeuel
The camera is not driven from the motor cards. The camera is attached to what is called a forcer. For the Y axis there are two of them. One is wired backwards from the other. one of the forcers is connected to a flex chanell for the air and electrica
Electronics Forum | Tue Jul 20 12:49:38 EDT 2004 | mmjm_1099
We are having a problem with our Heller 1800W oven with certian parts skewing. It seems that some inductors and taller Can caps are shifting around in the oven. It seems it will solder fine and than all of a sudden just be off to one side or the othe
Electronics Forum | Tue Aug 17 10:09:34 EDT 2004 | Phil Z
From my perspective, regardless of the size of your company, you want the best value for your money and latest, greatest in innovation. For pick and place, while Mydata, Siemens and Assembleon/Yamaha all have some cool and worthy concepts and worth e
Electronics Forum | Wed Aug 18 00:53:16 EDT 2004 | Grant
Hi, I think you cannot go wrong with Convection. If you want to experiment with VP, just get some of the fluid and put it into a pasta cooker on a standard domestic hot plate. Have a basin full of cold water so after reflow you can lift the cooker a
Electronics Forum | Tue Oct 26 10:49:00 EDT 2004 | Simon UK
Hi, > > I'm planning to get a new oven. I wanna > know the advantages and disadvantages of each > oven type over each other. I'm being told to go > for an 8 zone oven. > > thanks for your > help. > > regards, Depends really if you want a dua
Electronics Forum | Tue Oct 26 15:44:35 EDT 2004 | Paul_pmd
Hi Mike, Surface mount components arn't difficult to work with at all. They have pretty much the same tolorance to heat degridation as Dip packages. I suggest two Irons when working with two pole resistors and caps. Heating only one end at a time wil
Electronics Forum | Fri Apr 22 14:28:38 EDT 2005 | Gary Goldberg - PROMATION
Low end selective laser soldering systems are limited to what types of soldering can be performed. I have read through the previous comments and find that most have commented on earlier technologies (which do not offer the features today's system do)
Electronics Forum | Tue May 03 09:47:03 EDT 2005 | denismeloche
We sell rework stations for all kind of components and boards. The systems are designed to fit a particular size board and it's very difficult to design a one size fits all system. I personally have a lot of experience reworking high mass, high hea
Electronics Forum | Thu Jun 09 13:30:34 EDT 2005 | PWH
I would suggest 7mm thick "Durostone" as a carrier material. Cut lip/pocket for PCB so it is 0.05" thinner than thickness of PCB. Allow 0.010" gap on all sides of PCB. Machine lip to width between 0.050" and 0.100" to support under perimeter sides
Electronics Forum | Mon Jun 27 09:09:19 EDT 2005 | Bob R.
We've all been soldering Pb free parts for a couple decades. All your surface mount capacitors have probably had a Sn finish for years. Whenever one of our parts with a SnPb finish converts for Pb free we have the manufacturing site do a small buil