Electronics Forum | Wed Aug 16 05:13:41 EDT 2000 | Charles S
Are you running high volume. If yes then what you propose may be relevant. If however you run low volume - lots of changeovers then your wastage/transfer will be equal if not greater than the amount put on the boards. Enclosed systems like DEK Proflo
Electronics Forum | Tue Aug 01 08:57:34 EDT 2000 | CAL
We here at ACI run the CP20 or Manncorp version 2000.We are a Research and engineering Company with availablity for demonstrations. We actually love our system (Esp. the cost). Even though our machine is a low end machine we are placing advanced pack
Electronics Forum | Thu Jul 13 13:44:21 EDT 2000 | Gary Kemp
I would like to receive a few recommendations from users through experience for post reflow AOI equipment. Anyone with specific information regarding Mfg., programming time, cost, etc., please post your your recommedation. Thanks.
Electronics Forum | Wed May 24 03:23:30 EDT 2000 | Dane Stokes
I would like to here some opinions from the industry on the DEK 265 models. All feed back positive or negative would be welcome. Main concerns are the Vortex and Proflow options are they worth the cost, or do they just add complications and extensive
Electronics Forum | Mon May 15 10:46:51 EDT 2000 | PhilB
You should also consider intrusive reflow (aka pin in hole relow� but be aware of the thermal possibilities of your through hole components and ask support from a stencil supplier that has done this before. Hope this helps, Phil
Electronics Forum | Mon May 08 11:49:18 EDT 2000 | Steve Thomas
Thanks Dave. Figured you'd come through on that one. Any recommendations for a source, and for other good reading as well? Found a Brit site, but would like to avoid international shipping costs if possible...... Thanks again. Steve
Electronics Forum | Mon May 01 19:49:36 EDT 2000 | dave A
Do yourself a favor and hire someone who's been there done that. If your not familiar with the equipment or the operation of SFMT the industry can be overwhelming. Since the cost of installing a line can be expensive, there's no room for error.
Electronics Forum | Thu Apr 20 02:34:27 EDT 2000 | erico
Hi everbody , Could some one plaese tell me that how long and the cost to test a SMT chip with ICT?
Electronics Forum | Wed Apr 12 21:12:35 EDT 2000 | Dave F
Kevin: I'm back. Essentially what you're doing is: trading the cost of a stencil against the throughput you give-up by dispensing. Interesting Dave F
Electronics Forum | Tue Apr 04 05:56:52 EDT 2000 | Wolfgang Busko
Sorry to hear that Electrovert isn�t much help in your situation but the manufacturer of a system should be the first source of information on the equipment regarding preventive maintenance and troubleshooting. You should try to get in touch with th