Electronics Forum | Thu Jul 28 18:53:32 EDT 2011 | rway
Make sure your system is not in bypass mode (under conveyor setup). Also, the intermittent SMEMA signal can cause the conveyor to turn on until it times out. Check your sensor on the upstream conveyor. Cover it and check your diagnostics to ensure
Electronics Forum | Tue Mar 31 15:14:53 EDT 2009 | kpm135
Is your machine an inline system with the conveyors along the back? If so I have run into this problem before with the sensors on the covers for the conveyors. They are 'magnetic' safety switches that can appear to be closed but don't actually switch
Electronics Forum | Tue Oct 20 08:38:17 EDT 2015 | nhel_0009
good day, we're encountering trouble in CM602 Mounter and still looking for help..here is the error(cover open A stage front and rear, ext conv open/ConveyorHoleSensorDetect, Outside cover open, Momentary power off. Anyone knows the error ple
Electronics Forum | Thu Mar 30 07:44:19 EST 2006 | Chunks
UP 2000 is a good printer. Spares are normal - blades, stencil/board light bulbs, the over head flourecent, get new conveyor belts. Take the cover off the tactile sensor and make sure it's clean also. Other than that it should be a work horse.
Electronics Forum | Mon Aug 31 15:21:04 EDT 2015 | zombee
Dear Users! I have a Topaz pick&place machine, but the conveyor motor is not working. 1st test - production: Start production in "operation" menu: if I put the PCB the entrace of machine, the assembly head-bank picks up the first 8 components (prec
Electronics Forum | Fri Apr 22 08:00:50 EDT 2005 | bobpan
we had schematics and a disk inside the rear cover assy in ours. You may want to check under that cover.
Electronics Forum | Thu Sep 29 19:45:23 EDT 2011 | edwaterfall01
The conveyor is programmed to turn off the belts and go into an error condition after 30 seconds if the board has not passed the output sensor on the conveyor. The intent is to indicate a board jam and prevent damage to the board or belts. On convey
Electronics Forum | Thu Jun 14 00:10:18 EDT 2012 | tech1
Most of it depends upon the type of Y wagon you have. if they are internal conveyors you need to remove the covers from the operator side. There are 3 screws holding the Y wagon down, 2 of them are hex screws and the one in front is an allen head. W
Electronics Forum | Mon Jan 20 09:55:09 EST 2003 | Claude_Couture
The carrier tape and cover tape of static sensitive components are either conductive or dissipative. as for the P&P machine, as long as they are made of metal and grounded, static buildup is not an issue. All PCB conveyors I've seen have static condu
Electronics Forum | Mon Aug 08 12:46:05 EDT 2005 | Joe
I need a knowledgable technician to do a l-r r-l change over on a jot buffer. we can either send the machines to you, or we will be willing to fly you down and cover expenses. if anyone knows someone please send me their phone number, and email.
