Electronics Forum | Mon Mar 17 03:50:12 EDT 2008 | Sean
Hi All, Besides the above question, I have another one as below: (1) How frequent that we need to perform strain gauge study on ICT, Functional test fixture? Is it a necessary to perform this study each time after ICT, Funtional test fixture preve
Electronics Forum | Thu Aug 08 13:09:38 EDT 2013 | cyber_wolf
Hege, there is no actual calibration of the thermocouple itself. You can however verify that they read correctly. Heller sells an option on their reflow ovens specifically for this purpose. I hoping that someone chimes in here that is NADCAP certifi
Electronics Forum | Thu May 10 15:11:53 EDT 2001 | jdtpfacreate
Paul, My company offers an excellent solution for low volume/high mix applications. The issue always becomes how can you reduce downtime/changeover. There are few features on our machines that allow you to do this effectively: -Load feeder
Electronics Forum | Mon May 10 22:59:42 EDT 2004 | Grant Petty
Hi, Thanks for the info, and we are considering a CP7, as if we are going to spend the money, we might as well go all the way and get the speed. However I have seen some video of them operating, but am yet to see one. What is the placement accuracy
Electronics Forum | Wed May 20 14:03:53 EDT 2020 | dwl
Buy a dryer to go with your compressor. Compressed air traps a lot of water and you don't want that in your air lines on your P&P machines. Additionally, make sure you keep up with all the preventative maintenance and change out the filters as requir
Electronics Forum | Sat Nov 07 18:18:58 EST 2015 | ttheis
Hi everyone, We just got our first wave soldering machine operational (novastar 8s) and its working great. I'm just a little unsure about how to best maintain the foam fluxer daily. Do you drain it from the machine each day or just cover the flux t
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
1 |