Electronics Forum | Tue Feb 15 00:27:39 EST 2011 | jeffr
First clean and de-bur the hole in the nozzle, then try it again. If the Head does not pick up at the feeder, then moves to the dump position...it means that the Vacuum Sensor Board has detected that the nozzle vacuum is above the LOW threshold setti
Electronics Forum | Mon Nov 14 00:13:55 EST 2011 | tpappano
Hi Jeff, I pulled the proms from both machines, copied to disk, re-burned the the old versions with the newer and reinstalled. The ram became scrambled in the upgraded unit on startup, but I did a full restore through the serial port and unit #2 got
| 1 |
