Electronics Forum | Mon Jun 22 17:37:03 EDT 1998 | Dave F
| | | | hi all. | | | I am looking for a oven which can cure the conformal coating providing heat and the humid atmosphere. I am looking for a temperature range of 60 deg C to 80 deg C and a humidity range of around 80%. | | | Can anybody refer to
Electronics Forum | Fri Jun 19 15:17:54 EDT 1998 | Chris Jackson
We are in the process of validating Silicon 1C55 (thermal cure) conformal coating over Alpha LR725 solder paste. I am looking for anyone who may be using this process, or has been exposed to someone who is doing this process. Our concern is with the
Electronics Forum | Thu Mar 05 16:25:27 EST 1998 | Brian Stumm @ ETS
| I am looking for information on reflow temps for a flex board. There is only one 6 pin IC but the board has a 3M double sided tape. | Is it possible to reflow without damaging the tape. Any suggestions? Do you have a profiler for your reflow oven?
Electronics Forum | Tue Nov 27 15:37:15 EST 2001 | Dave G
I've seen some glass melf's fall off in our facility due to the glue not adhering to the body very well. You could pick these off with your finger after they had cured. (With little or no effort - I never bothered to actually measure the force requir
Electronics Forum | Tue Apr 02 22:58:10 EST 2002 | davef
Whatever I've said, my intent has never been to insult you. Smack you yes, insult you no. True, you never said the word �strings� but you did say � * �� shouldn't I be able to expect enough green strength from my epoxy to hold 0603 caps in place wi
Electronics Forum | Sun Apr 21 19:56:57 EDT 2002 | francis khoo
Hello Pete, Very true about the heel fillet. Looks like the pad at pcb has to be designed such that the pad should extend at heel but short at toe. About the encapsulation. I can understand the requirements. Can you provide me with a more detail proc
Electronics Forum | Mon Jul 01 20:42:54 EDT 2002 | davef
Comments [questions] are: * It�s strange that an uggie ol� SOIC, 50 pitch, BIG honkin� solder pad, kinda thang is failing. Sumpin aint kosher, yano? * Where is the failure occurring [ie, lead to pad, pad to board, etc]? Talk about the breadth and di
Electronics Forum | Sun Oct 13 22:19:28 EDT 2002 | mikestringer
Hi Everyone What lubricants do your maintenance people use for the chains in your Reflow ovens? The manuals for our ovens have one recommendation - but I am always open to other people�s experiences and recommendations. Another option may be easie
Electronics Forum | Mon Feb 24 10:21:29 EST 2003 | ryanm
Just an update on my problem. I spoke to Loctite and they had very few solutions. One thing they suggested to try was to add a thirty-second soak time at 150 degrees to my reflow profile. The problem with that is ramp-soak-spike profiles doesn�t s
Electronics Forum | Sat Nov 08 09:42:22 EST 2003 | ethercom
Hi: I have seen this problem before. It is caused by improper curing of solder mask by the fab manufacturer. When you run the board thru' wave solder, and then wash the board, you see the problem of white residue. However, when you apply heat, you c