Electronics Forum | Thu Apr 19 08:32:14 EDT 2007 | Hussman
We are running a proto using the Zierick Bottom Entry Through-Board Stockets. http://www.zierick.com/pages/sm_bts1260.php Anyone currently using these or the 1280 design? My question is they over this part on tape and reel and wanted to know how y
Electronics Forum | Wed May 02 11:51:40 EDT 2007 | flipit
Check with Universal on service. The GSM is a solid machine. Very well built. The older machines will run under IBM OS2 OS. Nothing wrong with this OS. There have been some vision system upgrades also. The older GSM might have the AIS3500 or ne
Electronics Forum | Thu May 17 09:53:14 EDT 2007 | mohdfazuwan
For ur information, this BGA machine was full utilize every day. I have more than 100 model to do profiling every week. Different PCBA with different thickness & material need different temp setting. currently i'm looking for profiler that more compa
Electronics Forum | Fri May 11 09:51:52 EDT 2007 | rgduval
We use MyData direct up here in the New England. Always seemed easiest to me. In a previous life, I did use an independent contractor. She used to work at MyData and serviced my machines in an even more previous life. Then branched out on her own
Electronics Forum | Fri May 11 10:48:51 EDT 2007 | Rob
Hi Lupo, Are you talking about laser trimming the current limiting resistors in front of the LEDs, whilst dynamically measuring their output to get set light levels? If so then you need a laser trimmer & a very good photodiode/comparator feedback l
Electronics Forum | Fri Jun 22 09:56:30 EDT 2007 | grics
Good Morning! I was curious if anybody would be able to help point me in a direction where I can research process control on spray fluxing. Our spray fluxers tend to be neglected. We currently are applying flux and running. My goal is to setup pr
Electronics Forum | Fri Jun 22 11:02:13 EDT 2007 | gregf912
I have a CP642E machine that will not function if auto adjust is enabled in Part Descriptor. Symptom: Auto pick offset causes machine to pick part off center to the point of going to end of part after several picks. This only happens to parts that ha
Electronics Forum | Fri Jun 29 09:40:46 EDT 2007 | dphilbrick
We have 2 ovens and 2 wave solder machines using nitrogen. When we were running 2 shifts a day 6 days a week we were spending about $3500 per month. Currently running 1 line 5 days a week we are at about $650 per month. These costs include taxes, tan
Electronics Forum | Tue Jul 03 10:57:01 EDT 2007 | randomtech
To start, i do not know much about this industry. I am an inventor, and designed an electronic device. I am currently building the prototype myself. I need to find out where i can get this product produced. I would need PCB, component assembly, p
Electronics Forum | Wed Jul 18 02:19:50 EDT 2007 | vijayanandh
PANASERT MViiF --> PANASERT MSF --> BTU Reflow Currently we're facing massive problems with MViiF(chip shooter) nozzles being damaged and broken. Anyone around who is facing the similar problems? We're looking into the feeders (worn out base/problem