Electronics Forum | Tue Apr 17 13:07:17 EDT 2012 | rodrigo
Well... after much headache I found a bad relay contact in M1CR1E. The good news is somehow the axis are no longer jerking. The bad news is that it still does not work. When I turn it on now it shows this: emergency stop (in red) waiting for reset
Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Thu Apr 12 17:49:35 EDT 2012 | rodrigo
I've done the Fuji flush. It does the same thing. We can not load proper again because it does not communicate with either the F4G or MCS/30. I was able to boot into mechanical mode at one point but now I can not do that either. This thing is drivi
Electronics Forum | Mon Apr 16 13:31:36 EDT 2012 | jdengler
Have you tried to restart F4G and/or MCS/30 after flushing the CP4 memory? I have occasionally ran into the comm error after a reset start. Leave the machine on and restart F4G or the MCS/30 whichever normally is hooked up. If it still won't commu
Electronics Forum | Fri Dec 16 19:19:59 EST 2022 | gabriel1blue
Hi guys. I have an old panasert pick and place machine that I'm trying to get working, but now we encounter an error after we power up the machine but when we try to complete origin process. Everything completes the process except for DST-PSOI and af
Electronics Forum | Tue Jul 09 15:20:19 EDT 2002 | pjc
When you look at the capabilities of Combo machines they tend to sacrifice performance when compared to separate X-ray and AOI machines, meaning they don't do either the X-ray or AOI operations as well as a machine that was designed to do only one. A
Electronics Forum | Tue May 18 21:43:02 EDT 2010 | ashley
Hello mickd, 1) The EL data & Vision_type is NOT necessary when using MCS30 for IP1 machine. note : your input of the above might have cause confusion during VP, hence the OS error. 2) I would suggest the following... 2a) lower the Lead_check_are
Electronics Forum | Mon Nov 12 17:12:40 EST 2001 | slthomas
Thanks, Dave. Three courtesy cheers for specifications written to reflect the capabilities of the part suppliers, even if they fail to meet the purchaser's (not unreasonable) process req'ts. In the meantime, I'm sure my stencil guy would be more
Electronics Forum | Mon Nov 12 13:04:35 EST 2001 | slthomas
We've got a problem with a fine pitch board that has about .005" registration error at each end (towards the center of the board) when it's printed. Apparently we've got a case of board stretch generated at the fab shop. I still have to do some mea
Electronics Forum | Mon Nov 12 16:14:47 EST 2001 | davef
Yes!!! How can we assemble boards with 20 pitch when we allow 0.008� error to the master art? Excellent question!!! IPC-D-300G has nothing to do with assembler requirements. It is written by and for fabricators, so that they can be comfortable.
.png)