Electronics Forum | Wed Jul 09 09:27:02 EDT 2003 | MA/NY DDave
Hi Saw a Cross Section picture and thought of you You noted above that you couldn't find any pictures or descriptions of your problem in a few well known sources. It probably is not what you are experiencing yet a soldering defect called land lift
Electronics Forum | Mon Jul 14 16:26:58 EDT 2003 | slthomas
Yes, they do the cleaning, we did the (apparently first) inspection and caught the problems. They tried a shorter cleaning cycle, witnessed no defects, and attributed the defects on the boards we had to their cleaning process. Now they just plan on
Electronics Forum | Wed Jul 02 12:42:58 EDT 2003 | slthomas
Not sure how else to describe this. We've received some boards (1/2" x 3.5" x .0325" board built on panels of 24) with numerous resistors showing separation of the solder from the metallization at the top of the joint. There are 26 0805's on the bo
Electronics Forum | Tue Jul 15 10:44:49 EDT 2003 | MA/NY DDave
Hi, Although I grit my teeth it does sound like a normal process engineer or engineering situation. Here you are with knowledge and ways to get knowledge of best practices and No One listens. ----- Now I have a cleanliness testing joke (real sto
Electronics Forum | Mon Jul 07 11:36:11 EDT 2003 | slthomas
It's definately soldering because the fillet is pulling the solder plating (I believe, from what I can see under available magnification) off of the termination, and some of the nickel plating as well.
Electronics Forum | Wed Apr 16 13:19:13 EDT 2003 | Takfire
Thanks Russ! The origianal complaint from the customer was in regards to what appeared as "bumpy" appearance and "holes" in the solder fillet. This problem was originally presented as an appearance issue only. Further investigation by our DPA lab r
Electronics Forum | Wed Apr 16 10:45:16 EDT 2003 | Takfire
Recent cross-section analysis for a customer complaint revealed voiding in the solder fillet. In some cases, the remains of outgassing were also observed. During the failure analysis, we also observed failures where the solder fillet wicked on the
Electronics Forum | Mon Jul 07 11:40:32 EDT 2003 | davef
If it's soldering, you have good plating.
Electronics Forum | Thu Apr 17 13:35:49 EDT 2003 | davef
A-610 talks to acceptable voiding.
Electronics Forum | Thu Apr 17 18:18:34 EDT 2003 | davef
We undoubtedly will take you up on that offer. Please email contact information.
