Electronics Forum | Thu Nov 30 00:41:23 EST 2017 | abhilash4788
Dear All, I have OSP finsh pcb on my production, the pcb thickness is 1.5mm and the product is one sideded pcba. After reflow process, Is there any specific time frame defined for smt completed OSP finish pcba before going for wave soldering proce
Electronics Forum | Sat Sep 08 08:55:24 EDT 2007 | davef
We expect to see a copper shadow along the edge of pads when soldering boards with organic solderability protection [OSP]. IPC-A-610 has defined this as acceptable for years. During early reflow stages, the flux in paste dissolves the OSP where ther
Electronics Forum | Thu Jun 19 08:15:28 EDT 2003 | rmurtuza
Which is the best surface finish to be used on non- solder mask defined pads in terms of cost and reliability? What are the advantages and disadvantages of the various surface finishes such as Ni/Au , Cu OSP , Ni /Pd and HASL.
Electronics Forum | Tue Oct 21 11:42:04 EDT 2008 | arosario
Hi Shooter, we're not using AOI but we do every 30 minutes sampling Inspection on the board and we're not seeing insufficient paste deposit so far since we started. But I agree with you that seemed my printer is not printing consistent amount of pa
Electronics Forum | Sun Jun 20 16:58:31 EDT 1999 | Chrys Shea
| Has there anyone bold enough to try this in their shops? My cubemate just got through telling me that at his last shop, they had bare copper boards (no HASL, no OSP, no nothing), with minimal solderability problems. | Is your cubemate the same gu
Electronics Forum | Fri Jun 18 20:09:52 EDT 1999 | Dean
| Has there anyone bold enough to try this in their shops? My cubemate just got through telling me that at his last shop, they had bare copper boards (no HASL, no OSP, no nothing), with minimal solderability problems. | yes, 8 years ago I developed
Electronics Forum | Thu Apr 01 21:18:31 EST 1999 | Chris Kelly
Glenn, There are both very good VOC-Free fluxes as well as alcohol based fluxes out there. This should be your primary focus if you are so lucky as to have to opportunity to actually select a flux! The use of nitrogen will benefit any no-clean pro
Electronics Forum | Tue May 26 21:27:33 EDT 1998 | Earl Moon
| | | | | I'm reviewing my board fab spec. It calls for a minimum SnPb thickness of 50 microinches on HASL PWB's. I've looked at other specs that call out anything from 30 to 80 microinches, and others that just say the copper pad must be covered a
Electronics Forum | Wed May 27 11:19:34 EDT 1998 | Earl Moon
| | | | | | I'm reviewing my board fab spec. It calls for a minimum SnPb thickness of 50 microinches on HASL PWB's. I've looked at other specs that call out anything from 30 to 80 microinches, and others that just say the copper pad must be covered
Electronics Forum | Sun May 23 07:13:56 EDT 1999 | Scott Cook
| Has anyone had any experience or data using vibration during the reflow process. | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process worked v
