Electronics Forum | Mon Mar 24 15:54:36 EDT 2008 | Paul M.
What r u using for fiducials ? fids? pads? thru-holes? video model? What r u using to print the paste? squeege blades? proflow? paste puck? Why r u using Step Mode ?
Electronics Forum | Mon Mar 24 17:16:27 EDT 2008 | hussman
Double check your supports. When run in auto this occurs a lot quicker than step mode. Just a thought.
Electronics Forum | Wed Mar 26 16:10:13 EDT 2008 | kpm135
When was the last time your ELA was calibrated? I had an operator ding the camera some how and the machine acted very much as you describe afterwards. A camera calibration corrected the problem.
Electronics Forum | Wed Mar 26 19:00:48 EDT 2008 | darby
Also check your belts/tensions/pulleys and motors on the camera axis. If you are getting any slippage then the camera will not be in the position the encoder says it is. It may still read the fids but will produce an offset.
Electronics Forum | Mon May 19 13:44:03 EDT 2008 | john_smith
Charlie, The EKRA printer is not a bad choice if you are just trying to upgrade from a table top unit. The DEK is much better and would be money well spent.
Electronics Forum | Wed Jun 03 06:45:38 EDT 2009 | aj
machine wont initialise after breaker tripped when machine was powered down over the weekend. All PSU's check out fine along with Estop circuit. I get the command to press system button but thats as far as it goes. any ideas welcomed
Electronics Forum | Sat Mar 27 23:44:16 EDT 2010 | dekhead
You were doing it right... for a 288. 3rd or 4th time in the last year or so I've had somebody do that. Glad I could help. http://www.dekhead.com
Electronics Forum | Sat Apr 03 14:17:26 EDT 2010 | dman97
Thanks again for your help. I never would have guessed to check the SPC data settings because we never use it. Thanks so much!
Electronics Forum | Mon May 03 08:42:12 EDT 2010 | dekhead
The $20K number thrown out there by the OEM would lead me to believe there is something else going on and/or it's the black camera vision... green/silver they usually use the $10K. DEKHEAD
Electronics Forum | Wed Aug 03 20:54:06 EDT 2011 | dekhead
The "low line" DEKs are made in China now (same ones marketed in China under the ICON nameplate)... Higher level are still made in UK... I thinkk similar with MPM; I know they are still producing machines in Mass... Both suffer from cost down manufa