Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
Electronics Forum | Thu Feb 14 23:08:41 EST 2013 | dekhead
Squeegee error on a 248 is strictly that sensor (reed SW) on corresponding (Front / rear) squeegee cylinder is not seeing a change in state... Either a physical obstruction preventing cylinder from exending fully - OR- if it is extending fully, then
Electronics Forum | Thu Feb 14 13:10:58 EST 2013 | markhoch
I had this problem once a loooooooong time ago with a 248 that was at my previous place of employment. If I remember correctly, my issue was caused by a set screw on the drive gear that had worked itself loose. My issue was stright forward and quickl
Electronics Forum | Fri Feb 15 21:52:06 EST 2013 | nikyta
Most likely it is a faulty cable in the e-chain . You can test it in diagnostic: lower the back squeege and manually move back and forth for its entire travel the print carriage while monitoring the sensor output of the squeege. You will see at some
Electronics Forum | Fri Jun 22 20:46:10 EDT 2007 | nickh
I ran into an error with our DEK 288 machine, when I go to initialize the machine the following error occurs: Squeegee Height: Error Input Active. This occurs with or without a squeegee present, and I have tried restarting multiple times, but the sa
Electronics Forum | Tue Jun 26 11:18:41 EDT 2007 | ck_the_flip
But DEK's are the best printers out there!
Electronics Forum | Mon Aug 18 10:42:04 EDT 2008 | floydf
We are in the process of preparing for a new board that requires paste in hole processing. The hole is a .020" via, and our customer wants it filled with solder, but not bulging past flush. For printers,we use a DEK 249 with a squeegee, and a DEK 260
Electronics Forum | Thu Aug 27 03:19:21 EDT 2020 | dekhead
Have you done Squeegee Heights calibration? (no tools required) Does it complete cal routine without error? Does pressure compensate on next print, with corresponding squeegee, following acknowledgement of pressure error? The readings calibration, ge
Electronics Forum | Tue Jun 26 10:53:25 EDT 2007 | chrisgriffin
Have no idea what that is, but I have a 288 here. Wanna buy it?
Electronics Forum | Tue Jun 26 17:49:04 EDT 2007 | nickh
Don't need to buy one, we have 3 laying around here, they're great when they work...