Electronics Forum | Thu Nov 03 18:20:15 EST 2005 | JG
Dek 265 GS Problem: Machine abruptly turns off. It can be in the middle of a stroke or just sitting idle. After the machine turns off we have to let it sit for a few minutes (sometimes 20) in order for it to restart. Any suggestions? Thanks in adv
Electronics Forum | Thu Jul 16 16:56:02 EDT 1998 | Doug Nebel
| Howdy 2, | I am using my first DEK GSX PRINTER. Looks and acts good so far. Who know what - good, bad, or in between? Just want to get the facts from those who know. | Earl Moon We have had our 265 GSX a little over 2 years. Print quality has bee
Electronics Forum | Thu Aug 16 07:46:50 EDT 2012 | omur
We have the following problem with our DEK265GS during start-up: Loading Program... Loading Language... Stack Overflow! Any help / pointers would be much appreciated. Omur...
Electronics Forum | Sun Aug 26 15:09:18 EDT 2012 | aelektronik
Did you try running an AV scan on your files.
Electronics Forum | Mon Jul 30 01:14:37 EDT 2018 | erici
Our DEK 265LT wont boot up with the DEK software. It says that the current version of the software can only run a 265GS printer, and to install the correct release of the software. Has anybody encountered the same problem? It just started happenin
Electronics Forum | Mon Jul 30 17:08:58 EDT 2018 | erici
Thanks for your reply. I did as per your suggestion, but the problem still persists. Here is the exact error i get whenever i re-start the pc "This programme can only runa 265GS printer. This machine has been indentified as a standard 265 printer.
Electronics Forum | Thu Aug 16 11:15:38 EDT 2012 | menatech
delete the pointer readings.dek. If the printer loads after restart is the problem a corrupt program (last printed product. if this not work could it be a problem with the DEK config file. save the the file on floppy and delete it from the m/c. the s
Electronics Forum | Thu Aug 30 04:40:38 EDT 2012 | menatech
could be a hardware problem (processor board, harddrive) but this overflow message is most times software related. delete the calib file for an other trial. have you the machine software for reinstall?
Electronics Forum | Sat Aug 25 08:22:38 EDT 2012 | omur
Thanks for the pointers. I just tried both of your suggestions - but still the "Stack overflow" message is appearing. Any other suggestions ?
Electronics Forum | Mon Aug 27 03:22:04 EDT 2012 | omur
As the machine was working before - and as it is not connected to any network and we do not use the floppy disks, I do not think that it is related to a virus.
winsouce.jpg)
