Electronics Forum | Thu Jan 31 09:00:15 EST 2008 | d0min0
Hi, we have 4 DEK 265 infinity, all with blue underscreen cleaner (with paper rolls), it doesn't make miracles :) but if you have good solvant system (not too much - you flood the paper and not too small) then works OK on some of our DEKs (y 2000) t
Electronics Forum | Tue Jul 30 12:30:21 EDT 2013 | JB
We are breaking a 1995 Dek 265GS screen printer for spares, it has the blue under screen cleaner, green 2D inspection camera. Was in full working order before getting a new Dek printer installed. The reason for replacing it was the air line pipes had
Electronics Forum | Sun Mar 04 02:39:27 EST 2012 | eadthem
I don't have our DEK printer part numbers memorized, In general we have a older machine running NT4.0 . It has 2Di inspection but we never use it because you can only inspect/setup 1 camera shot at once, making for very long programming. Our newer D
Electronics Forum | Thu Oct 03 18:45:56 EDT 2002 | davef
Get started with an "On-Board Forum" [blue bar an inch down from the top of the page] moderated by Jeff Schake at DEK that was a discussion focused on stencil printing issues with 0201 technology. Chris: Are you putting 0201 on flex? If so, sounds
Electronics Forum | Thu May 16 04:54:33 EDT 2013 | aj
Hi all, I have an intermittent problem on a 265 GSX printer. "Position error" on the rising table.. quite a lot of work has been done with no success. such as motor, break , encoder replaced....diagnostic checks etc.... Machine could run for a few
| 1 |
