Electronics Forum | Fri Apr 29 23:52:03 EDT 2022 | Stevekilic
Hello, I have a problem with Dek horizon 03ix machine software hangs on the start screen. What could be the matter.
Electronics Forum | Wed May 25 12:09:52 EDT 2022 | stevemiles
Hi, I've had this problem with two DEK Horizon 03i printers. The first time it was the camera (firewire) causing the PC to freeze. The second time it was the firewire card in the PC that was the problem. Try moving the camera firewire cable to a d
Electronics Forum | Fri Oct 02 21:40:49 EDT 2015 | gafur
hi all...please give me advice..my machine dek horizon 03ix error can node machine I/O...thank's before...
Electronics Forum | Sat Oct 03 06:01:38 EDT 2015 | gafur
yes i've...main I/O node 2 already swap with other dek horizon machine...the result is good...
Electronics Forum | Sat Oct 03 00:52:23 EDT 2015 | dekhead
Have you checked status on main machine I/O (Node 2) on the rear of the machine? LED status? www.dekhead.com
Electronics Forum | Fri Mar 13 17:43:16 EDT 2015 | loganting
how helpful is it to use alignment weighting over fiducial offsets ?
Electronics Forum | Fri Mar 13 17:11:23 EDT 2015 | loganting
2 fiducial alignment vs 3 fiducial alignment , any opinion ? When do we actually need the third fiducial for alignment ?
Electronics Forum | Fri May 29 06:50:04 EDT 2015 | buckcho
Hello, can you explain better what do you want to check? Alignment is done based on fiducial check and then you can do some offsets, based on the print. So I am not sure what do you want to say...
Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Mon Oct 24 14:01:18 EDT 2022 | angela t
Do you know what the difference is between the DEK Horizon 03IX and DEK Horizon 8 printers?