Electronics Forum | Fri Apr 29 23:52:03 EDT 2022 | Stevekilic
Hello, I have a problem with Dek horizon 03ix machine software hangs on the start screen. What could be the matter.
Electronics Forum | Thu Aug 16 07:46:50 EDT 2012 | omur
We have the following problem with our DEK265GS during start-up: Loading Program... Loading Language... Stack Overflow! Any help / pointers would be much appreciated. Omur...
Electronics Forum | Mon Jul 30 01:14:37 EDT 2018 | erici
Our DEK 265LT wont boot up with the DEK software. It says that the current version of the software can only run a 265GS printer, and to install the correct release of the software. Has anybody encountered the same problem? It just started happenin
Electronics Forum | Mon Dec 22 08:20:34 EST 2003 | kauerr
Hi,I am a Mfg. Engineering Tech. and do Maintenance on all of our Equipment. 4796 HSPs, Dek 265 LT screen printers, GSMs, ect. We have 6 lines of equipment with certain operators assigned to each line, and you can really tell which operators do or do
Electronics Forum | Mon Mar 01 22:51:05 EST 2021 | rob1
We have a DEK 265 Horizon and it exhibits a problem with conveyor belts. When I power up the DEK and try to paste boards, it fails to initialize the conveyor. I have to go into Maintenance and select cycle boards on rails. This too fails, but when I
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
Electronics Forum | Mon Mar 03 12:30:13 EST 2008 | vikkaraja
That was the first thing I did. I reloaded the software and machine actually started to work. After 2 hours machine crapped out again with same problem.
Electronics Forum | Thu Feb 17 17:33:34 EST 2022 | mnorthey
Hi all, I have a Dek 265 Horizon that fails to print at the correct pressure. It fails pressure every pass. I am trying to Calibrate it with a PFR1200N pressure Tester which we use for our DEK 248 Printers. I am trying to build up the table height
Electronics Forum | Sun Jul 18 12:13:06 EDT 2021 | oriolsancheza
Hello, Our machine started to not stopping board into the right position (stop pin was not working we guess). After some inspection we have not seen anything strange. However the DEK software decided to not work anymore. We've been messing arrounf
Electronics Forum | Fri Jan 05 12:02:28 EST 2018 | ilavu
Camera works fine from home to ref. position to fiducial1 and 2. Problem shows up from home to board stop. AC voltage between AC1 and AC2 is 41.7 and during move it drops to 41.5.
