Electronics Forum: dek raising table (Page 1 of 12)

dek infinity

Electronics Forum | Mon Nov 18 02:45:06 EST 2013 | sara_npi

Hi What is "fatal error"? Every time when operator raise head to add cleaning paper or add solvent machine just hang like that. need to reboot machine. Pls advise Thanks.

dek infinity

Electronics Forum | Thu Nov 21 11:51:28 EST 2013 | dekhead

Best guess, not knowing specifics of error, would be a vision system error... connection issue wrt camera. Does system respond properly (prompts to raise / lower head) upon reboot? Specific error information would help in troubleshooting. DEKHEAD

How do I adjust table height EKRA X5 Screen Printer?

Electronics Forum | Tue Aug 04 13:45:03 EDT 2020 | oxygensmd

There are one value for thickness during PCB-teach function which is the PCB thickness. The other one is the camera focus in machine option but it is a dangerous function because the camera focus is adjusted by raising/lowering table.

How do I adjust table height EKRA X5 Screen Printer?

Electronics Forum | Wed Aug 05 06:34:33 EDT 2020 | oxygensmd

Yes if you adjust the thickness to be thin than the machine raise the PCB more to the stencil - than the foil have better tension but it string out faster.

DEK265 or DEK260 for high mix low volume ???

Electronics Forum | Mon Feb 20 17:56:46 EST 2006 | Chris

If you are running FR4 PCBs and not something exotic like Kapton flex circuits, I would go with the Dek 265 any day of the week. You will find that Dek supports the fully automatic printer much better than the semiautomatic printers like the 260, 24

DEK 03! CAN Node Rising Table Error

Electronics Forum | Thu Dec 22 11:18:59 EST 2022 | emanuel

I am interested to know if you solved this problem. We are experiencing something similar. The table is the first node in the CAN chain. As I see the structure, the CAN starts from the Nextmove ES card, goes first to the table driver and continues to

mpm up2000 z axis hardware limit

Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze

Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d

PCB Supports

Electronics Forum | Wed Jun 02 09:21:10 EDT 2004 | James

They take the place of the tooling pins. They magnetically attach to the table. Board comes in, table raises, Red-E-Set supports the board, prints, done. You just have to do the initial setup before running. We bought 4 units for each machine. J

MPM Ultrapint series 2000

Electronics Forum | Mon Jun 19 15:13:42 EDT 2006 | Chunks

There is also plastic link on the shaft that raises your Z-Table that may have come lose or broken. Is the Z-Table able to move up and down in Supervisor mode?

Dek 248.cerd

Electronics Forum | Sat Oct 08 17:47:33 EDT 2016 | goldentech

Dek 248.cerd tooling table stuck in the up position,any one can help. Thanks, Tom

  1 2 3 4 5 6 7 8 9 10 Next

dek raising table searches for Companies, Equipment, Machines, Suppliers & Information