Electronics Forum: delta wave problems (Page 1 of 162)

soltec delta wave

Electronics Forum | Wed Oct 21 13:50:50 EDT 2020 | kierantennant

hi, I am experiencing a problem with our wave solder machine where zone 2 (forced convection) fan will not work when called upon. so we swapped it with zone 3 to make sure the motor was not at fault and it wasn't so we moved the A1 into a different 2

What is delta t?

Electronics Forum | Thu Oct 25 11:29:04 EDT 2007 | ck_the_flip

Forget all the bickering and semantics. EVERYONE IS RIGHT!! ...but then again, in soldering, there IS no right, wrong, or indifferent... just blame. :-) Soldering is, after all, the most difficult process with the most opportunities for defects.

Vitronics Delta wave 6622c problems

Electronics Forum | Mon Oct 19 05:16:56 EDT 2015 | florintoma

Hello all, I have a problem with the wave 6622c . The temperature of solder pot and preaheating zones 1 and 2 is not increasing. the strange thing is that the machine is not display no error. Can you help me with some advices?? regards

soltec delta wave

Electronics Forum | Thu Oct 22 12:30:33 EDT 2020 | emeto

So is the initial motor at fault failing now or the one from zone 3?

Vitronics Delta wave 6622c problems

Electronics Forum | Tue Oct 20 10:14:59 EDT 2015 | aemery

Florin, Not sure if this will be helpful or not, but I have completed a couple of pot height retrofits for these waves and I seemed to remember that one of my clients spilled some solder and shorted out the 24vdc power supply. I am pretty sure this

Vitronics Delta wave 6622c problems

Electronics Forum | Mon Oct 19 09:59:30 EDT 2015 | cbeneat

I've never had that particular problem with our machine, but I do know that if the CB pop for whatever reason the machine doesn't give an error. So I would check those, if you haven't yet. Also under options you can do an element check, see if that

vitronics delta wave malfunction errors :pcb expected at exit

Electronics Forum | Fri Sep 14 03:43:16 EDT 2012 | mili

Hello!I have a delta wave with these problems:offtime of lambda wave tracking is too long and when modify offtime setting to a negative value for a fast stop on tracking position of lambda wave, the wave pass on stand-by with a delay of half of leg

Seho 1135C Wave Solder can't generate sufficient delta wave height

Electronics Forum | Thu Sep 26 23:14:25 EDT 2013 | zsoden

We picked up this old (circa late 80s) Seho 1135 machine last year for next to nothing. It needed a bit of TLC to bring it back to working order but it's 99% working now. The only problem left is that we cannot get sufficient height from the delta wa

vitronics delta backplate

Electronics Forum | Wed Feb 06 02:14:43 EST 2008 | mun4o

Hi, we use Vitronics Delta 6622 solder wave.I try to adjust high of backplate, but I don't know whether the adjustment is correctly.Now, when the frame enter in the main wave, solder flow in the same direction as PCB.But when the frame go above main

vitronics delta backplate

Electronics Forum | Thu Feb 14 04:40:38 EST 2008 | lococost

You want the backplate set up so that when there's no PCB the wave stands still or moves towards the PCB. When the PCB moves over the wave, it should just pull the wave towards the back (in the same direction as the PCB). This will help reduce brid

  1 2 3 4 5 6 7 8 9 10 Next

delta wave problems searches for Companies, Equipment, Machines, Suppliers & Information